MX-M264N/M314N/M354N Operation-Manual GB

SCANNER/INTERNET FAX
(1) (2)
Set blank page skipping.
Scan/Special Modes
OK
(1) Select the type of blank page to be skipped.
4
Blank Page Skip
Cancel
OK
Select from two types.
To include blank pages on which the content on the
opposite side shows through, touch [Skip Blank and Back
Shadow].
Skip Blank Page
Skip Blank and Back Shadow
(2) Touch the [OK] key.
5
Press the [START] key.
Scanning begins. A beep will sound to indicate that scanning is finished.
To cancel scanning...
Press the [STOP] key (
) to cancel the operation.
(A)
(B)
XX pages of original have (P.x)
been scanned.
YY sheets of original
will be Perform the job?
When scanning is completed, check the
number of original sheets and the
number of sheets to be sent, and touch
[OK].
6
(C)
Cancel
OK
Scanning begins.
• When Job Build mode is used, the confirmation message will
appear after the [Read-End] key is touched.
• The number of scanned original sheets appears in (A), the
number of scanned sides in (B), and the number of sheets to
be sent excluding blank pages in (C). For example, if five
original sheets that include two blank pages are scanned by
duplex scanning, (A) will show "5", (B) will show "10", and (C)
will show "8".
If this step is not performed for one minute while the above confirmation screen appears, the scanned image and
settings will be cleared and the base screen will reappear. Scanning will not be completed automatically and the
image will not be reserved for transmission.
When "Default Preview" is enabled in the system settings (administrator) and the skip blank pages function is used to scan
original pages, you can check the pages, including the blank pages, in the preview screen. For more information, see
"PREVIEW CHECK SCREEN" (page 5-70).
To cancel the Blank Page Skip function...
Touch the [Cancel] key in the screen of step 4 so that it is no longer highlighted.
System settings (administrator): Original Feeding Mode
Use this setting to always skip blank pages when sending.
5-97
Contents