07.07.2014 Views

MX-M264N/M314N/M354N Operation-Manual GB

MX-M264N/M314N/M354N Operation-Manual GB

MX-M264N/M314N/M354N Operation-Manual GB

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

FACSIMILE<br />

4<br />

Press the [START] key to scan the first set.<br />

To cancel scanning...<br />

Press the [STOP] key ( ).<br />

5<br />

Insert the next set of originals and press the [START] key.<br />

Repeat this step until all originals have been scanned.<br />

To cancel scanning...<br />

Press the [STOP] key (<br />

). All scanned data will be cleared.<br />

Place next original. (Pg.No.x)<br />

Press [Start].<br />

When finished, press [Read-End].<br />

Touch the [Read-End] key.<br />

Configure<br />

Read-End<br />

6<br />

• If no action is taken for one minute after the confirmation screen appears, scanning automatically ends and the<br />

transmission is reserved.<br />

• The [Configure] key can be touched to change the exposure, resolution, scan size, and send size for each original<br />

page scanned. However, when Job Build is used in combination with 2in1 in the special modes, only the exposure<br />

can be changed when scanning each even-numbered page of the original pages.<br />

• If the memory becomes full during scanning, a message will appear and the transmission will be cancelled.<br />

• This function cannot be used in direct transmission mode or when the speaker is used to dial.<br />

To cancel Job Build...<br />

Touch the [Job Build] key in the screen of step 3 so that it is not highlighted.<br />

4-88<br />

Contents

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!