MX-M264N/M314N/M354N Operation-Manual GB

SYSTEM SETTINGS
Paper Type Registration
Store a paper type when the desired paper type does not appear as a selection or when you wish to create a new set of
paper properties.
Up to 7 paper types can be stored.
Item
Description
Type Name
Fixed Paper Side
Disable Duplex
Disable Staple
Store any name.
The factory default names are "User Type 1" - "User Type 7".
Enable this setting when paper with a front and reverse side is used.
Enable this setting when paper is loaded that cannot used for two-sided printing.
Enable this setting when paper is used that cannot be stapled.
The settings that can be selected vary depending on the peripheral devices installed.
Auto Tray Switching
When a tray runs out of paper during printing, this determines whether or not another tray with the same size and type of
paper is automatically selected and printing continues.
Custom Size Registration (Bypass)
If you frequently use a special non-standard paper size in the bypass tray, you can store that paper size.
Storing the paper size saves you the trouble of setting the size each time you need to use it.
Up to three paper sizes can be stored.
Touch the key ([Custom 1] to [Custom 3]) in which you wish to store or change a paper size. The following screen will
appear:
System Settings
Custom 1
Cancel
OK
Size Input-AB
Size Input-Inch
X 432
mm (148-432)
Y 297
mm (100-297)
Select whether you wish to enter the size in mm ("Size Input-AB") or inches ("Size Input-Inch"), and then set the X and Y
dimensions of the paper.
"Size Input-AB"
The X dimension can be set to a value from 140 mm (when a finisher is installed, 148 mm) to 432 mm. The factory
default setting is 420 mm.
The Y dimension can be set to a value from 100 mm to 297 mm. The factory default setting is 297 mm.
"Size Input-Inch"
The X dimension can be set to a value from 5-1/2" (when a finisher is installed, 5-7/8") to 17". The factory default setting
is 17".
The Y dimension can be set to a value from 5-1/2" to 11-5/8". The factory default setting is 11".
7-15
Contents