Infortrend RAID Controller Manual

9-8
9.4 Configuration: Host and Drive Parameters
Drive Channel
Host Channel
View and Edit Fibre Channel
Channel Mode:
Every I/O channel can be configured as host or drive by changing its
"Channel Mode."
Primary and Secondary Controller IDs:
Select a channel by highlighting its status bar and press [ENTER].
Following are parameters to set in redundant controller mode:
Each drive channel should be assigned with both a "Primary
Controller ID" and a "Secondary Controller ID." By default, the
primary and secondary IDs on drive channels are 119 and 120.
Each logical unit (logical drive/logical volume/logical partition)
can be mapped to a Primary controller ID or Secondary controller
ID independently.
Communications Channel:
A host channel can be selected and converted into a communications
channel. To convert a drive channel, change it into host mode and
then select "RCCOM." Details can be found in the proceeding
discussions.
Infortrend