Infortrend RAID Controller Manual

NOTE:
11. Type "Pathname" for value name, and set data type to
REG_EXPAND_SZ, then click on "OK" button.
12. Type "%SystemRoot%\System32\RAIDSNMP.DLL" for string,
then click on "OK" button.
13. Close REGEDT32, then the SNMP Agent is ready for Infortrend
RAID Manager.
14. Restart the SNMP service or restart your system.
• The names and values in the NT registry are case sensitive.
13.11.4 How to Configure the SNMP Trap
1. In order to let the SNMP trap working properly, the
"RAIDCOMM.INI" file must be copied in the system root directory
(\WINNT).
2. The Descriptions of Contents of the "RAIDCOMM.INI"
Examples:
[TRAP]
PERIOD=30
SEVERITY=0
Comments:
A There should be a section of "trap". The value of "PERIOD"
specify the minimum interval of sequential traps. It is in
seconds. For example, as above, it is 30 seconds.
B The value of "Severity " is a filter to mask the traps that is less
than its value. The value of "Severity" is considered when the
value of "PERIOD" is positive.
C The SNMP agent communicates to the RAID controller
through in-band SCSI by default. To change the
communication route to RS-232C, please refer to the next
paragraph.
D While the Text RAID Manager is running and communicates
to the RAID controller through the in-band SCSI, the SNMP
traps will not be able to send. It is a must to exit the Text
RAID Manager in order to send the SNMP trap properly.
E While the Text RAID Manager is running locally, the remote
SNMP connection (GUI via SNMP) cannot be established. It is
a must to exit the local Text RAID Manager in order to
perform remote administration via SNMP.
3. The SNMP agent communicates to the RAID controller through inband
SCSI by default. To change the communication route to
RS-232C, please add:
In-band Text RAID Manager and SNMP Agent Installation 13-29