Infortrend RAID Controller Manual

12-28
Select partition
Mapping optioin
Mapping a Logical Drive/Logical Volume to the Host
LUNs
Select LUN number
Confirming mapping
scheme
Choose “host channel-ID”
Choose mapping to which “logical unit”
Terminal Interface View of Controller Failure
What will happen when one of the controllers fails?
When one of the controllers fails, the other controller will take over in
a few seconds.
A warning will be displayed that a "SCSI Bus Reset Issued" for each
of the SCSI channels.
In addition, there will be an alert message that reads "Redundant
Controller Failure Detected."
Users will be notified by audible alarm.
After a controller takes over, it will act as both controllers. If it was the
Primary controller that failed, the Secondary controller becomes the
Primary controller. If the failed controller is replaced by a new one
later, the new controller will behave as the Secondary controller.
Infortrend