Infortrend RAID Controller Manual

• SNMP MIB file ("RAIDSNMP.MIB")
• The README file for installation ("README.TXT")
Note that the installation procedure for both Windows NT/2000 and
Windows 95/98 is the same except for the procedure for installing the
system SNMP service.
Driver/Utility Package Installation:
1. Insert package installation diskette into a 3.5" 1.44MB floppy
drive.
2. Copy RAIDMAN.EXE and RAIDCOMM.DLL to
\system32.
where:
is the path corresponding to the system root
directory of Windows NT.
Example:
COPY A:\RAIDMAN\WINNT\RAIDMAN.EXE C:\WINNT\SYSTEM32
COPY A:\RAIDMAN\WINNT\RAIDCOMM.DLL C:\WINNT\SYSTEM32
3. Now, you can run RAIDMAN anywhere to manage Infortrend
RAID controllers through RS-232, host bus and SNMP interface.
Note: The SNMP service must be installed before using SNMP
interface.
Executing the Text RAID Management Utility
To execute the Text RAID Management Utility, simply execute the file
"RAIDMAN.EXE".
13.11.1 Before Using In-band SCSI Text RAID
Manager
• In order to let the In-band SCSI utilities (Text RAID Manager or
GUI RAID Manager) communicate with the RAID controller
correctly, it is a must to set the corresponded Peripheral Device
Type if there is no logical drive map to the host channel SCSI
ID/LUN.
• Please refer to the README.TXT in "\3102\DISK" of this CD disc,
or refer to the Instruction Manual for more detail information
about "Peripheral Device Type" setting.
13.11.2 Use In-band SCSI Text RAID Manager to
Configure RAID
1. In a Windows NT system with Infortrend RAID controller
properly connected to the Host Bus Adapter (SCSI interface or
Fibre interface) of the system, insert this CD disc into CD-ROM
drive. Use "Windows Explorer" or open a "Command Prompt" to
execute the "RAIDMAN.EXE" located in
"\3102\disk\winnt\raidman.exe" of this CD.
In-band Text RAID Manager and SNMP Agent Installation 13-27