Infortrend RAID Controller Manual

13-10
13.5 NetWare
Introduction:
The Driver/Utility package for NetWare is in the
"\3102\DISK\NETWARE" directory on the installation CD-ROM:
• In-band SCSI driver for NetWare ("ASPICOMM.NLM")
• RAID Asynchronous I/O NLM ("RAIDAIO.NLM")
• ("RAIDCOMM.IN_")
• In-band SCSI Text RAID Manager for NetWare
("RAIDMAN.NLM")
• Sample MIB file ("RAIDSNMP.MIB")
• SNMP extension agent for NetWare ("SNMPCOM.NLM")
13.5.1 Before Using In-band SCSI Text RAID Manager
for NetWare
1. Copy all the files in this directory into the NetWare directory.
C:\> copy d:\3102\ndisk\netware\*.* c:\nwserver
(where "d:" refers to the driver letter of the CD-ROM drive, and
"c:\nwserver" refers to the NetWare directory.)
13.5.2 Use Text RAID Manager to Configure RAID
1. Boot up the NetWare server. Make sure the driver and ASPI
manager of the SCSI adapter (or Fibre adapter) are both properly
loaded.
Example of using the "2940U2W" SCSI card:
ServerName: load aic78u2 (the SCSI adapter driver)
ServerName: load nwaspi (the ASPI Manager)
(For NetWare 5 users: the "nwaspi" is located in "\nwserver
\drivers", use "load c:\nwserver\drivers\nwaspi" to load the
ASPI manager under NetWare 5.)
Example of using the "2940UW" SCSI card:
ServerName: load aic7870 (the SCSI adapter driver)
ServerName: load aspitran (the ASPI Manager)
(For NetWare 5 users: use ".HAM" driver for the "2940UW" card,
type "load aha2940" and "load c:\nwserver\drivers\nwaspi" to
load the .HAM driver and ASPI Manager under NetWare 5.)
2. Load "ASPICOMM" for driver of Infortrend RAID controller.
ServerName: load c:aspicomm
3. Load "RAIDMAN" for the In-band SCSI Text RAID Manager.
ServerName: load c:raidman
Infortrend