Infortrend RAID Controller Manual

NOTE:
4. Create Primary and Secondary IDs on Host Channels:
"View and Edit SCSI Channels"→ Choose a host channel→ "View
and Edit SCSI ID"→ Choose a SCSI ID→ "Add/Delete Channel
SCSI ID"→ "Primary/Secondary Controller"→ Add SCSI ID from
the list. Reset the controller for the configuration to take effect.
5. Create Logical Configurations of Drives and assign each of them to
either the Primary or the Secondary Controller:
"View and Edit Logical Drives"→ Select a RAID level→ Select
member drives→ "Logical Drive Assignments"→ Create Logical
Drive.
6. Map Each Logical Configuration of Drives to the Primary/
Secondary ID on host channel(s):
"View and Edit Host LUN"→ Choose a "host channel-IDcontroller"
combination→ Choose Logical Drive/Logical
Volume/Physical SCSI Drive→ Map to Host LUN (Create Host
LUN Entry).
• The redundant function of the controllers can be enabled via the front keypad or a
terminal emulation program. Section 12.3 describes the procedures for using the
terminal emulation and LCD front panel. The same result can be achieved regardless
of the interface used.
Redundant Controller 12-13