Infortrend RAID Controller Manual

3. Create and configure one or more logical drives or logical volumes.
The host and drive channel configuration depends on your
application topology. Map the logical units you created to Host
IDs/LUN combinations.
4. Save your configuration. The configuration information can be
saved to logical drives or as a file in host system disk. When all
the RAID configuration is done, use the “Save NVRAM to Disk”
function (please refer to Chapter 6 and Chapter 8) to save your
configuration data. You may also use the forms in Chapter 11 of
this manual to keep a hard record of your configuration.
5. Initialize your system and proceed with installing your operating
system.
RAID Planning 3-9