Infortrend RAID Controller Manual

9-12
Figure 9 - 3 Dual Loop Configuration
Controller firmware will automatically examine the node names and
port names of all the connected drives once initiated. If devices on
two different drive channels appear with the same loop ID and port
name, controller will consider these two drive channels as a "dual
loop."
The dual loop configuration will be displayed as "channel ." For example, channel numbers are displayed as 2 and
3 if channel 2 and channel 3 are configured in a dual loop. The
data bus will be operating at the bandwidth of up to 200MB/sec.
Controller Unique Identifier
Infortrend