Infortrend RAID Controller Manual

6-6
6.4 Creating a Logical Drive
To create a logical drive, press ENT for
two seconds to enter the Main Menu.
Use ▼ or ▲ to navigate through the
menus. Choose "View and Edit Logical
Drives," and then press ENT.
Press ▼ or ▲ to select a logical drive,
then press ENT for two seconds to
proceed. "LG" refers to Logical Drive.
Choosing a RAID Level:
Press ▼ or ▲ to choose the desired
RAID level, then press ENT for two
seconds. "TDRV" (Total Drives) on the
LCD refers to the number of available
SCSI drives.
Choosing Member Drives:
Press ENT for two seconds, a message
“RAID X selected To Select drives” will
appear. Confirm your selection by
pressing ENT.
Press ENT, then use ▼ or ▲ to browse
through the available drives. Press
ENT again to select/deselect the drives.
An asterisk (*) mark will appear on the
selected drive(s). To deselect a drive,
press ENT again on the selected drive.
The "*" mark will disappear. "C=1 I=0"
refers to "Channel 1, SCSI ID 0".
After all the desired drives have been
selected, press ENT for two seconds to
continue. Press ▼ or ▲ to choose
“Create Logical Drive,” then press ENT
for two seconds to start initializing the
logical drive.
Logical Drive Preferences:
You may also choose “Change Logical
Drive Parameter,” then press ENT to set
other parameters before initializing the
logical drive.
View and Edit
Logical Drives
LG=0
Not Defined ?
TDRV=4 Create
LG Level=RAID5 ?
RAID X Selected
To Select drives
C=1 I=0 1010MB
NEW DRV SEAGATE
Create Logical
Drive ?
Change Logical
Drive Parameter?
Infortrend