Infortrend RAID Controller Manual

13.2 Windows NT for DEC Alpha
Introduction:
The Driver/Utility package for Windows NT for DEC Alpha is in the
"\3102\DISK\ALPHANT" directory on the installation CD-ROM:
• RAID Communications Interface DLL ("RAIDCOMM.DLL") to
interface with the Text RAID Management Utility and/or RAID
SNMP extension agent to communicate with a standalone RAID
controller over the host SCSI bus.
• INI file for RAIDCOMM ("RAIDCOMM.INI")
• In-band SCSI Text RAID Manager for Windows NT
("RAIDMAN.EXE").
• RAID SNMP extension agent ("RAIDSNMP.DLL") to interface with
a remote RAID subsystem configuration/monitoring utility.
• SNMP MIB file ("RAIDSNMP.MIB").
13.2.1 Before Using In-band SCSI Text RAID Manager
• In order to let the In-band SCSI utilities (Text RAID Manager or
GUI RAID Manager) communicate with the RAID controller
correctly, it is a must to set the corresponded Peripheral Device
Type if there is no logical drive map to the host channel SCSI
ID/LUN.
• Please refer to the README.TXT in "\3102\DISK" of this CD disc,
or refer to the Instruction Manual for more detail information
about "Peripheral Device Type" setting.
13.2.2 Use In-band SCSI Text RAID Manager to
Configure RAID
1. In a Windows NT system with Infortrend RAID controller
properly connected to the Host Bus Adapter (SCSI interface or
Fibre interface) of the system, insert this CD disc into CD-ROM
drive. Use "Windows Explorer" or open a "Command Prompt" to
execute the "RAIDMAN.EXE" located in
"\3102\disk\winnt\raidman.exe" of this CD.
2. The In-band SCSI Text RAID Manager provides a similar user
interface to RS-232 Terminal. Please refer to Chapter 8 of the
Instruction manual for the detail operation of the Terminal
Emulation of Text RAID Manager.
13.2.3 Install SNMP Agent for Windows NT
The SNMP agent for Infortrend RAID controllers can be installed by
the "Infortrend GUI RAID Manager" installation. To install the SNMP
agent manually, please follow the following procedures:
In-band Text RAID Manager and SNMP Agent Installation 13-3