running machine - H-P-COSMOS Sports and Medical
running machine - H-P-COSMOS Sports and Medical
running machine - H-P-COSMOS Sports and Medical
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
maintenance & safety inspections<br />
Alternatively you can also use a spray (with a thin spraying canal) of fat-dissolving fluid (e.g. braking detergent). The<br />
pressure on the detergent when coming through the spraying canal will cleanse the optics of the light barrier.<br />
When adjusting the light barrier take care to keep the<br />
following guidelines for the spaces between the glass [3]<br />
<strong>and</strong> the casing [4] of the light barrier: Cleft [1] axial<br />
approx. 1 mm/radial approx. 1 mm left <strong>and</strong> right<br />
according to illustration above. The imaginary extension<br />
of the light barrier has to pass through the centre [2] of<br />
motor shaft.<br />
Right h<strong>and</strong> side: The distance [1] between induction<br />
sensors [2] to the cogwheel [3] must not be bigger than<br />
0.8 mm.<br />
[9.K] Cleansing <strong>and</strong> adjustment of the light-barrier at belt-re-entry-zones<br />
Some models (<strong>running</strong> surface 200/75cm <strong>and</strong> bigger) are equipped with light-barriers at the <strong>running</strong> belt re-entry zone<br />
(rear position <strong>and</strong> front position for the reverse of belt rotation). As a safety measurement the light barriers effect a<br />
quick-stop function when the light stream is interrupted by a h<strong>and</strong>, a falling towel, a coat <strong>and</strong> of course, also by dust at<br />
the glass <strong>and</strong>/or reflector of the light barrier.<br />
To avoid unwanted switch off (quick stop), the light barrier <strong>and</strong> the reflector glass should be cleansed carefully with a<br />
cloth moistened with alcohol in intervals of 1 week, depending on the air <strong>and</strong> dust conditions in the room.<br />
Adjustment (direction <strong>and</strong> focus) of the light barrier can be checked when it is dark in the room.<br />
In case the cleansing of the light barrier does not result in success, you need to check <strong>and</strong> correct adjustment (direction<br />
<strong>and</strong> focus) of the light barrier. A special small screwdriver is required for adjustment of the focus. Talk about the<br />
procedure to your h/p/cosmos service partner.<br />
Light barrier must not be exposed to dazzling flash light of cameras. They might turn off <strong>and</strong> stop<br />
the <strong>running</strong> belt abruptly.<br />
file: n:\article\cos14310m5-v1_06hpc-en\20120215_cos14310m5-v1.06hpc-en_manual_h-p-cosmos_<strong>running</strong>_<strong>machine</strong>.doc<br />
© 2012 h/p/cosmos sports & medical gmbh email@h-p-cosmos.com created 15.02.2012 printed 15.02.2012 page: 140 of 213