running machine - H-P-COSMOS Sports and Medical
running machine - H-P-COSMOS Sports and Medical
running machine - H-P-COSMOS Sports and Medical
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
[10.I1] E20 Elevation system<br />
exceeded the max. value<br />
file: n:\article\cos14310m5-v1_06hpc-en\20120215_cos14310m5-v1.06hpc-en_manual_h-p-cosmos_<strong>running</strong>_<strong>machine</strong>.doc<br />
© 2012 h/p/cosmos sports & medical gmbh email@h-p-cosmos.com created 15.02.2012 printed 15.02.2012 page: 148 of 213<br />
trouble shooting<br />
= „E 20“ ! „ELEV“ flashing<br />
§ $ % „HELP“ flashing<br />
Running <strong>machine</strong> is still functioning (except for the lift device)<br />
N Lifting element exceeded the maximum value. The combined<br />
0% / maximum % -contact had been activated<br />
N Incorrect measurement of angle of elevation<br />
N Maybe wrong adjusted, dirty or defective elevation sensor<br />
N Contact authorized service engineer<br />
E21 Error of elevation system = „E 21“! „ELEV“ flashing<br />
§ $ % „HELP“ flashing<br />
Running <strong>machine</strong> is still functioning (except for the lift device)<br />
N Maybe technical blocking of elevation (e.g. overload)<br />
E30 Error of<br />
speed / distance measurement<br />
N Maybe power supply too weak because of an extension cable<br />
etc.<br />
N Check power supply <strong>and</strong> power cord<br />
N Maybe elevation sensor adjustment is wrong or the sensor is<br />
dirty or defective<br />
N Contact authorized service engineer<br />
= „E 30“ ! „INCR“ flashing<br />
§ $ % „HELP“ flashing<br />
Running <strong>machine</strong> can still operate for a few seconds at speed of<br />
max. approx. 1 km/h<br />
N Maybe technical blocking of <strong>running</strong> belt (e.g. alien element,<br />
towel trapped in device)<br />
N Maybe power supply too weak because of an extension cable,<br />
etc.<br />
N Check power supply <strong>and</strong> power cord<br />
N Maybe speed sensor adjustment is wrong, the sensor may be<br />
dirty or defective or the speed calibration is wrong. OPTION 34<br />
N Safety delay time (inverter or MCU) is longer than the high<br />
acceleration comm<strong>and</strong> (SPRINT function or high acceleration<br />
level)<br />
N Trouble shooting see Administrator OPTION 48<br />
N Contact authorized service engineer<br />
N Check voltage supply. Do not use extension cords. Connect<br />
the <strong>machine</strong> direct to the socket in the wall<br />
N Check mechanical parts for any malfunction. Maybe several<br />
persons were st<strong>and</strong>ing on the <strong>machine</strong> for a moment?<br />
N Remove pleated bellow from upper frame (where applicable,<br />
depending on frame).<br />
N Attention: Dangerous voltage <strong>and</strong> danger of being hurt when<br />
the device is open. Do not touch the parts inside the device
Change language