Curlin 4000 User Manual - Med-E-Quip Locators

LCD Display:Alert:Cause:Resolution:Note: Access to the programming screens is lock level restrictive.If the actual amount in the source bag/container is sufficient to completethe programmed infusion, press “YES” to start the infusion.Note: If the infusion is continued without sufficient volume, air-in-lineor up occlusion alarms may occur later in the infusion.ALERT AMT TBI LESS THAN AMT INFUSEDUnable to change amount to be infused to an amount less than what hasalready infused.Occurs when user tries to change the Vol TBI / Amt TBI field in theprescription menu to an amount lower that the amount which has alreadyinfused.Recheck the data entry. If alert recurs, resume the infusion and observethe Vol Inf / Amt Inf field on the run menu. The value for data entrymust be greater than the value displayed on the run menu.TroubleshootingLCD Display: ALERT BOLUS DOSE IS NON-ZEROAlert: Unable to enter a bolus interval or # of boluses/hour of “0”Cause: Bolus interval or # of boluses/hour value entered is zero, and bolus dosevalue is non-zero. When a bolus value is entered, there must also be avalue greater than 0 entered for bolus interval and # of boluses/hour.Resolution: Recheck data entered for the prescription.LCD Display:Alert:Cause:Resolution:LCD Display:Alert:Cause:Resolution:LCD Display:Alert:Cause:Resolution:ALERT BOLUS DOSE NOT ALLOWEDA bolus dose is not allowedBolus key or button pressed when no bolus dose is programmed.If bolus doses are part of the prescription, modify the Rx/titrationprogram to allow bolus doses.ALERT BOLUS REQUESTEDNot time for bolusBolus button or key is pressed before the programmed time intervalbetween bolus doses have elapsed.Advise patient of time limits between bolus doses per agency protocols.ALERT CALCULATED AMT OUT OF RANGEInvalid calculated amount for infusionThe calculated amount for the infusion, based on the values entered forRate and Time, exceeds either the pump limit or the value entered for bagvolume.Recheck data entry for Rx.121