Curlin 4000 User Manual - Med-E-Quip Locators

IMPORTANTINFORMATIONWhenever an external source is powering the pump, it is stillimportant to always install the two “C” size batteries. In the eventof a power failure or accidental power cord disconnection, thebatteries will power the pump without interrupting the therapy inprogress. If the batteries are in place when the power cord isdisconnected, the display will say “External Power Disconnected,”the alert beep will sound, the batteries will take over powering thepump, and the therapy will continue infusing.Handling and Storage:Store at room temperature. Avoid mechanical or electrical abuse.Do not short, charge or install incorrectly. Do not mix with otherbattery types, as (alkaline-manganese dioxide with carbon-zinc).Replace both batteries at the same time. Do not store batteriesloose. Refer to battery manufacturer's material safety data sheet forspecific product recommendations and precautions.IntroductionExternal Power SourcesBattery PackThe battery pack is an external, rechargeable, battery pack than can be used as an additional, longlife,portable, external source of power. It is rechargeable by plugging the AC Adapter into therecharging port. The battery pack is connected to the pump via the two-hole port located on thebottom of the pump (as shown below). The two-pin connector plugs into the receptacle correctlyby aligning the red dots on each.Note: Pause the pump and then turn it off before connecting the Battery Pack. Note also thatthe connector is keyed with a “notch” at this red-dot location to guide alignment. To remove, pullback on the locking sleeve to unlock and then pull gently to remove the connector from thepump’s port.19