Curlin 4000 User Manual - Med-E-Quip Locators

More documents

Recommendations

Info

The time format (12 hr AM/PM or 24 hr Military) selected in the BIOMED SETUP Menuwill apply in this table; and, if Military was selected, the AM/PM field will not appear here. Ifthe entire delay start screen is to be aborted, press the “NO” key at the ACCEPT field. Whenthe start time and date are entered and the data is accepted after the “YES/ENTER” key ispressed, the infusion is set to start at the programmed time. The display then returns to thenext field in the Pre-Prescription Menu.After the entire prescription program is accepted, if the pump is turned OFF and back ON,press “YES” at PROGRAM and “YES” to REPEAT Rx. The cursor will automaticallyscroll through the program. No changes will be allowed in the Pre-Prescription Menu duringthis time, thus maintaining the originally programmed Delay Start time. To change the DelayStart time, press the “NO/CHANGE” key when the Run Options Screen is displayed:Run Options ScreenThis will allow the clinician to go back to review the program and at this point a change canbe made to the delay start time.Note: If the pump is not connected to the patient’s access site at this time, the patient orcaregiver should be taught proper techniques to access the infusion site before thescheduled start time.When the “”RUN” key is pressed, the Green and Yellow LED lights will flash to indicate thatthe pump will automatically start when the delay start countdown period is up. During thedelay start time, the following screen appears:If the KVO rate is set to 0, the pump will beep ten minutes prior to the beginning of thetherapy start time. To stop the audible beep, press the “Silence” key.IMPORTANTINFORMATIONDuring the delay start period, if the KVO rate is set to 0, no fluid isinfusing. Be sure the access device is patent and has been flushedper facility policy to maintain patency during this time period. If aKVO rate is programmed, then that KVO rate will be used in theDelay Start period.2 NEXT?: If there are any changes to be made, use the up or down arrow keys to locate thefield to be changed, use the numeric keys to enter the corrected information, and press“YES/ENTER” to accept the new data. If all the fields are acceptable, move the cursor tothe “NEXT?” field and press the “YES/ENTER” key to move on to the next screen.74
At the following screen, the prescription information is entered to complete the programming ofthe pump:TPN Prescription ScreenNote that the screen identifier gives the abbreviation “TPN” for Total Parenteral Nutrition andhas a down arrow configuration, which indicates that there are more than four fields of text orinformation to be considered.1 BAG Vol (IV Bag Volume): Use the numeric keys to enter the amount of fluid in the IV Bagor Medication Reservoir (include the overfill volume).TPN TherapyNote: The volume used for priming via the pump or for KVO is deducted from the BagVolume. Therefore, Bag Volume should be equal to or greater than the Amount To BeInfused to start the infusion.When the correct amount has been entered, press the “YES/ENTER” key to accept thisfield and move on to the next. The range for this field is 1 to 9999.2 VOL TBI (Volume To Be Infused): Use the numeric keys to enter the actual volume ofinfusion to be delivered, excluding any KVO amounts. When the amount is correctly entered,use the “YES/ENTER” key to accept this field and to move to the next. (If VOL TBIentered is greater than Bag Volume, the pump will beep once. An alert message of “AMTTBI GREATER THAN BAG VOL” will appear to remind you to recheck and change thenumber before the “YES/ENTER” key will accept the value and move to the next field.)The range for this field is 1 to 9999.3 Inf RATE (Infusion Rate or rate of the level infusion): The Curlin Medical pump candeliver from 0.1 ml to 400 ml per hour. Use the numeric keys to enter the prescribed rate.When this field is correct, use the “YES/ENTER” key to accept the rate and move to thenext field. You may choose to let the pump calculate the rate by skipping this field andentering the up ramp time, down ramp, and total time.4 UP Ramp: This optional feature allows the beginning of the infusion to be gradually taperedup to the level infusion rate over a specified period of time. Enter the up ramp time periodusing the numeric keys, and when correct, press the “YES/ENTER” key to accept this fieldand move to the next. Since this field is optional, “0” may be entered and accepted. Therange for this field is 0:00 to 9:00 HH:MM.5 DN Ramp (Down Ramp): This optional feature allows the infusion to be gradually tapereddown over a specified period of time at the end of the level infusion. Enter the down ramp75
Page 1 and 2:
CURLIN MEDICALUser’s Manualfor us
Page 3 and 4:
TABLE OF CONTENTSEntering or Changi
Page 5 and 6:
TABLE OF CONTENTSPrime.............
Page 7 and 8:
IntroductionChapter1IntroductionThe
Page 9 and 10:
• Retained memory features that a
Page 11 and 12:
CAUTIONS• U.S. federal law restri
Page 13 and 14:
• This equipment generates, uses,
Page 15 and 16:
Serial Number LabelIntroductionBatt
Page 17 and 18:
Preparing Medication for Infusion/C
Page 19 and 20:
Opening and Closing the Pump DoorTh
Page 21 and 22:
Air DetectorNote: Open theslide cla
Page 23 and 24:
Installing the Batteries and Using
Page 25 and 26:
IMPORTANTINFORMATIONWhenever an ext
Page 27 and 28:
IntroductionLocking SleeveTwo-Pin A
Page 29 and 30: Chapter2Learning Pump FeaturesLearn
Page 31 and 32: LED Light IndicatorsThis “three-l
Page 33 and 34: Chapter3Basics of ProgrammingThe Cu
Page 35 and 36: whenever an alarm or error code occ
Page 37 and 38: Access CodeClinician Access Code Sc
Page 39 and 40: to all pump functions. Each level h
Page 41 and 42: 8 PRINT PATIENT HISTORY: To print t
Page 43 and 44: a. Time Format: You have the option
Page 45 and 46: If only one therapy is programmed a
Page 47 and 48: Chapter4Continuous TherapyContinuou
Page 49 and 50: If the KVO rate is set to 0, the pu
Page 51 and 52: 6 DONE?: If any changes are to be m
Page 53 and 54: The following screen displays the C
Page 55 and 56: detects in-line pressures at 400 mm
Page 57 and 58: In CMS-enabled pumps, the graphic b
Page 59 and 60: . If the incomplete therapy is to b
Page 61 and 62: PCA TherapyChapter5PCA TherapyPCA o
Page 63 and 64: a. MxRATE (Maximum Rate) limits: Us
Page 65 and 66: using the numeric keys and, when co
Page 67 and 68: Note. After the infusion has starte
Page 69 and 70: d. To exit the shift total feature
Page 71 and 72: pressures at 400 mmHg ±150 (8 ±3
Page 73 and 74: This screen will continue to displa
Page 75 and 76: When the program is accepted, the d
Page 77: which therapy to repeat by moving t
Page 82 and 83: time period using the numeric keys,
Page 84 and 85: 7 To continue priming, press the PR
Page 86 and 87: Note: Whatever Down Ramp time was a
Page 88 and 89: 1 The first field displays the “R
Page 90 and 91: . If the incomplete therapy is to b
Page 95 and 96: IMPORTANTINFORMATIONDuring the dela
Page 97 and 98: 10 DONE?: If there are any changes
Page 99 and 100: The following screen displays the I
Page 101 and 102: This message alerts you to the Air-
Page 103 and 104: Intermittent Information ScreensInt
Page 105 and 106: Intermittent Dosing ScheduleThe dos
Page 107 and 108: This screen displays:1 “INFUSION
Page 109 and 110: CHAPTER8Variable TherapyThis therap
Page 111 and 112: During the delay start period, if t
Page 113 and 114: 5 NEXT?: If there are any changes t
Page 115 and 116: 7 To continue priming, press the PR
Page 117 and 118: 4 DN Occlu (Down Occlusion): This f
Page 119 and 120: Variable Run Screen 2This screen di
Page 121 and 122: stop the auto-advance function by p
Page 123 and 124: The pump will then display the prog
Page 125 and 126: TroubleshootingChapter9Troubleshoot
Page 127 and 128: LCD Display:Alert:Cause:Resolution:
Page 129 and 130: If it is not necessary to preserve
Page 131 and 132:
Resolution:LCD Display:Alert:Cause:
Page 133 and 134:
LCD Display: ALERT NEW DOSE IS LESS
Page 135 and 136:
LCD Display:Alert:Cause:Resolution:
Page 137 and 138:
ALARMSAlarms are conditions that re
Page 139 and 140:
LCD Display:Alarm:Cause:Resolution:
Page 141 and 142:
ERROR CODESIf a pump goes into an e
Page 143 and 144:
ErrorCodeLCD DisplayedMessage162 St
Page 145 and 146:
ChapterAccessories10There are a num
Page 147 and 148:
AccessoriesFigure 10.3 Safety Shell
Page 149 and 150:
Keypad CoversThese accessories are
Page 151 and 152:
Chapter11Cleaning, EnvironmentalCon
Page 153 and 154:
1 PARTIES COVERED BY THIS WARRANTY:
Page 155 and 156:
d Program the following CONTINUOUS
Page 157 and 158:
Chapter12TechnicalSpecificationsThe
Page 159 and 160:
ITEMDown Occlusion Detection TimeMi
Page 161 and 162:
Curlin pump inusing at .1 ml/hr w i
Page 163 and 164:
Percent Error, Curlin Pump infusing
Page 165 and 166:
Clinician Information andAccess Cod
show all

Curlin 4000 User Manual - Med-E-Quip Locators

Create successful ePaper yourself

Delete template?

Save as template?