Curlin 4000 User Manual - Med-E-Quip Locators

AC Adapter/ChargerThis accessory (Universal AC Adapter 340-2022) becomes the external power source whenplugged directly into the Curlin Medical pump (see Figure 1.2 for external power port locationon the bottom of the pump). The AC Adapter can also be used to recharge the portable batterypack by plugging the connecting cable into the recharging port on the battery pack (see Figure1.12). The two-pin connector on the end of the cable plugs into the receptacles correctly byaligning the red dots on each.Note: Pause the pump and then turn it off before connecting the AC Adapter. Note, also thatthe connector is keyed with a “notch” at this red-dot location to guide alignment. Toremove, pull back on the locking sleeve to unlock and then pull gently to remove theconnector from the battery pack or pump’s port.Illustration of thebottom of the CurlinMedical PumpRecharging PortAlign the reddots and thenotches. Thenplug the twopinconnectorinto the twoholereceptaclelocated on thebottom of theCurlin Medicalpump.Locking SleeveTo charge the Battery Pack:Plug the AC Adapter into a grounded wall outletand then plug the AC Adapter into therecharging port of the Battery Pack (see above).On initial use, the Battery Pack should becharged for a full 24 hours, subsequent rechargetakes approximately 12 hours (overnight).Figure 1.12 Battery Pack20