Curlin 4000 User Manual - Med-E-Quip Locators

Note. After the infusion has started, any changes made through the OPTIONS menu involving:• “Clin DOSE”,• “SHFT TOT”• “HRLY TOT”, and• “CLR HRLY”will return you directly to the “ACCEPT OPT?” field.The following screen displays the PCA Therapy “Options” available. When you open this menu,use the up and down arrows to move the highlight bar to the desired option. Lock settings mayrequire an access code before the option can be changed. Any new setting, except “CLEARHOURLY” screen acceptance and “SHIFT TOTAL” clear screen acceptance becomes effectivewhen the “Options” screen is exited by pressing “YES/ENTER” at the “ACCEPT OPT?” field.PCA TherapyPCA Options MenuNote: The pump’s default settings are indicated above in the left screen.1 LOCK: When the lock is set to “OFF,” the clinician has access to all of the pump functions.After the pump is completely programmed, change the lock to meet the security needs of thistherapy. There are four choices: OFF, 1, 2, or 3. Each level higher limits the availableoptions. To change the lock setting, press the “NO/CHANGE” key until the correct locksetting appears. Then, press “YES/ENTER” key to accept the new lock selection. Once thepump has been set into a locked condition, any subsequent request to change the lock willrequire a clinician access code. (See “Clinical Information and Access Code” chapter foraccess code information, lock setting table and available features for each lock setting).2 ClinDOSE? (Clinician Dose): Allows an additional prescribed dose to be administered by aclinician at any time except during a Load Dose or Bolus Dose. The Maximum ClinicianDose is determined by the administration route (see Figure 5.1).Clinician Dose Menu61