Curlin 4000 User Manual - Med-E-Quip Locators

When the Curlin Medical pump successfully passes it’s self-test, a brief message of “SystemOK” appears, and the display moves to the next screen:Power Status ScreenThis screen displays the active power source of the pump, whether internal (batteries) or externalpower. If the active source is the C-size batteries, a bar graph will indicate the amount of powerremaining in the batteries. This graph is only an approximation of the charge left and is notintended to give a specific representation of battery life. The display will again automatically moveto the next screen:Preventive Maintenance ScreenThe above alert screen will appear after the Welcome Screen only when the Maintenance Duedate has arrived and will continue to appear until the date has been reset during the actualmaintenance performance. The pump may continue to be used after the maintenance due datebut should be returned for its routine maintenance at the earliest opportunity.Select Program or Bio-Med Setup ScreenThis screen is the first requiring you to act. It gives two selections from which to choose,“PROGRAM” or “BIOMED SETUP.” Using the up or down arrows, move the cursor to thedesired field and then press the ENTER key.Selecting “PROGRAM” allows you to proceed with choosing features and entering data requiredfor the pump to deliver a prescribed therapy.Selecting “BIOMED SETUP” allows the pump to be programmed and customized by theclinician to perform a number of special functions including setting the system clock. (See“BIOMED SETUP”) Accessing “BIOMED SETUP” requires you to enter a clinician accesscode. (Refer to the chapter entitled, Clinician Information and Access Code, of this manual.)30