Curlin 4000 User Manual - Med-E-Quip Locators

More documents

Recommendations

Info

LCD Display:Alarm:Cause:Resolution:UPLOAD CkSum ERRCMS Upload experienced a Check Sum ErrorAt the completion of an upload of a CMS script the Check Sum signaturefrom the CMS system did not match the signature calculated by the pumpA second attempt to upload the script should be made. If the secondattempt fails, then a new script should be created for the desiredprescription. (See CMS <strong>User</strong>’s <strong>Manual</strong>).134
ERROR CODESIf a pump goes into an error code, a numeric code will appear on the display screen. If this hasoccurred, turn the pump off and back on. If the error code message does not reappear, continueusing the pump.If the pump passes its start-up diagnostic tests, resume the therapy. If an error code recurs, turnthe pump off, replace it, and report the error code to the healthcare provider.ErrorCodeLCD DisplayedMessageProbable CauseCorrective Action10 Turn pump OFF/ON or ReplaceBattery or Call ProviderMotor Control Loss• Replace batteries.• Connect AC Adaptor.• Turn power off/on and resume.11 Turn pump Off/On Keyboard Buffer Full Report error code to factory.12 Air SensorAir In Line test circuit failure Report error code to factory.Turn pump Off/ONor Call provider13 Pressure Sens DNBad Down Strain Beam Replace set and Resume.Check Admin Set turn pumpOff/On14 Pressure Sens UP Check Admin Bad Up Strain BeamReplace set and Resume.Set Turn pump Off/On15 Turn pump Off/On or Call Bad EncoderReport error code to factory.Provider16 Turn pump Off/On or call Bad Analog to Digital Report error code to factory.ProviderConversion17 Turn pump OFF Call Provider Bad Clock Report error code to factory.18 Call Provider Bad Air In Line comparator Report error code to factory.register reading from FPGA.19 Turn Pump OFF Call Provider Bad Door Sensor Report error code to factory.20 Empty Lithium BatteryEmpty Lithium BatteryReport error code to factory.Call Provider21 Turn pump OffBad Tristate PinReport error code to factory.Call Provider22 Turn Pump OFFBad Test PinReport error code to factory.Call Provider23 Turn Pump OFFBad Reverence Voltage Report error code to factory.Call Provider24 Turn Pump OFFBad Motor SupplyReport error code to factory.Call Provider25 Stalled PumpBroken Motor ShaftTurn power off/on and resume.Turn pump OFF/ONCall Provider26 Turn Pump OFFBad Motor InhibitReport error code to factory.Call Provider27 Turn Pump OFFBad Motor Supply Enable Report error code to factory.Call Provider28 Turn Pump OFFCall ProviderBad Motor Logic Enable Report error code to factory.29 Low Alarm BattConnect AC AdaptTurn pump OFF/ON30 Turn Pump OFFCall Provider31 Turn Pump OFFCall Provider32 Turn Pump OFFCall Provider33 Low Alarm AudioConnect AC AdaptTurn pump OFF/ONLow Auxiliary Battery Connect pump to AC BatteryEliminator and turn power off/on topump. May require turning pumpoff/on a few times.Bad Auxiliary BatteryReport error code to factory.Audio Main Speaker LowAudio Main Speaker HighReport error code to factory.Check/replace D31. Replace PCB.Audio Auxiliary Speaker Low Connect pump to AC BatteryEliminator and turn power off/on topump. May require turning pumpoff/on a few times.Troubleshooting135
Page 1 and 2:
CURLIN MEDICALUser’s Manualfor us
Page 3 and 4:
TABLE OF CONTENTSEntering or Changi
Page 5 and 6:
TABLE OF CONTENTSPrime.............
Page 7 and 8:
IntroductionChapter1IntroductionThe
Page 9 and 10:
• Retained memory features that a
Page 11 and 12:
CAUTIONS• U.S. federal law restri
Page 13 and 14:
• This equipment generates, uses,
Page 15 and 16:
Serial Number LabelIntroductionBatt
Page 17 and 18:
Preparing Medication for Infusion/C
Page 19 and 20:
Opening and Closing the Pump DoorTh
Page 21 and 22:
Air DetectorNote: Open theslide cla
Page 23 and 24:
Installing the Batteries and Using
Page 25 and 26:
IMPORTANTINFORMATIONWhenever an ext
Page 27 and 28:
IntroductionLocking SleeveTwo-Pin A
Page 29 and 30:
Chapter2Learning Pump FeaturesLearn
Page 31 and 32:
LED Light IndicatorsThis “three-l
Page 33 and 34:
Chapter3Basics of ProgrammingThe Cu
Page 35 and 36:
whenever an alarm or error code occ
Page 37 and 38:
Access CodeClinician Access Code Sc
Page 39 and 40:
to all pump functions. Each level h
Page 41 and 42:
8 PRINT PATIENT HISTORY: To print t
Page 43 and 44:
a. Time Format: You have the option
Page 45 and 46:
If only one therapy is programmed a
Page 47 and 48:
Chapter4Continuous TherapyContinuou
Page 49 and 50:
If the KVO rate is set to 0, the pu
Page 51 and 52:
6 DONE?: If any changes are to be m
Page 53 and 54:
The following screen displays the C
Page 55 and 56:
detects in-line pressures at 400 mm
Page 57 and 58:
In CMS-enabled pumps, the graphic b
Page 59 and 60:
. If the incomplete therapy is to b
Page 61 and 62:
PCA TherapyChapter5PCA TherapyPCA o
Page 63 and 64:
a. MxRATE (Maximum Rate) limits: Us
Page 65 and 66:
using the numeric keys and, when co
Page 67 and 68:
Note. After the infusion has starte
Page 69 and 70:
d. To exit the shift total feature
Page 71 and 72:
pressures at 400 mmHg ±150 (8 ±3
Page 73 and 74:
This screen will continue to displa
Page 75 and 76:
When the program is accepted, the d
Page 77:
which therapy to repeat by moving t
Page 80 and 81:
The time format (12 hr AM/PM or 24
Page 82 and 83:
time period using the numeric keys,
Page 84 and 85:
7 To continue priming, press the PR
Page 86 and 87:
Note: Whatever Down Ramp time was a
Page 88 and 89:
1 The first field displays the “R
Page 90 and 91: . If the incomplete therapy is to b
Page 95 and 96: IMPORTANTINFORMATIONDuring the dela
Page 97 and 98: 10 DONE?: If there are any changes
Page 99 and 100: The following screen displays the I
Page 101 and 102: This message alerts you to the Air-
Page 103 and 104: Intermittent Information ScreensInt
Page 105 and 106: Intermittent Dosing ScheduleThe dos
Page 107 and 108: This screen displays:1 “INFUSION
Page 109 and 110: CHAPTER8Variable TherapyThis therap
Page 111 and 112: During the delay start period, if t
Page 113 and 114: 5 NEXT?: If there are any changes t
Page 115 and 116: 7 To continue priming, press the PR
Page 117 and 118: 4 DN Occlu (Down Occlusion): This f
Page 119 and 120: Variable Run Screen 2This screen di
Page 121 and 122: stop the auto-advance function by p
Page 123 and 124: The pump will then display the prog
Page 125 and 126: TroubleshootingChapter9Troubleshoot
Page 127 and 128: LCD Display:Alert:Cause:Resolution:
Page 129 and 130: If it is not necessary to preserve
Page 131 and 132: Resolution:LCD Display:Alert:Cause:
Page 133 and 134: LCD Display: ALERT NEW DOSE IS LESS
Page 135 and 136: LCD Display:Alert:Cause:Resolution:
Page 137 and 138: ALARMSAlarms are conditions that re
Page 139: LCD Display:Alarm:Cause:Resolution:
Page 143 and 144: ErrorCodeLCD DisplayedMessage162 St
Page 145 and 146: ChapterAccessories10There are a num
Page 147 and 148: AccessoriesFigure 10.3 Safety Shell
Page 149 and 150: Keypad CoversThese accessories are
Page 151 and 152: Chapter11Cleaning, EnvironmentalCon
Page 153 and 154: 1 PARTIES COVERED BY THIS WARRANTY:
Page 155 and 156: d Program the following CONTINUOUS
Page 157 and 158: Chapter12TechnicalSpecificationsThe
Page 159 and 160: ITEMDown Occlusion Detection TimeMi
Page 161 and 162: Curlin pump inusing at .1 ml/hr w i
Page 163 and 164: Percent Error, Curlin Pump infusing
Page 165 and 166: Clinician Information andAccess Cod
show all

Curlin 4000 User Manual - Med-E-Quip Locators

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?