Curlin 4000 User Manual - Med-E-Quip Locators

LED Light IndicatorsThis “three-light” feature gives the user feed back on the current status of the pump.1 Green indicates a RUNNING status of the pump and blinks approximately once every threeseconds when a therapy is in progress.2 Yellow indicates a STANDBY status of the pump and blinks while the pump is paused.3 Red indicates a STOPPED or ALARM status of the pump and blinks whenever an alarmstatus exists.4 Green and Red indicates an “Infusion Complete Alarm” status with KVO or a DownOcclusion Alarm with automatic restart.5 Yellow and Green indicates a “Standby” status with automatic start. This occurs during anydelay start with a “0” KVO programmed or in PCA during a “0” basal rate and bolus onlyprogrammed.Audio IndicatorAn audible alarm or “beep” is used to alert you to a change in the status of the pump or asituation requiring user action or notification. A message will appear on the display screendescribing the situation. The rate, number of beeps, and volume further specify status. Thispump offers nine different volume levels from which to select for the audio feature; however, the“beep” cannot be totally disabled. The audio “beep” can be silenced for one-minute intervals bypressing the “SILENCE” key except during an “Error Code,” at which time the alarm continuesand the pump must be turned off. The chapter of this manual entitled, Troubleshooting includestables with the alerts, alarms, and error codes, the conditions causing them, the message displayedon the screen, and the actions required for resolution. If an alert or alarm occurs, please refer tothese tables.Learning PumpDisplay ScreenThe display screen provides a maximum of four lines of text, or fields, at any one time forfeedback regarding the pump status and data entry. It notifies the user with prompts or messageswhen necessary. The screen has backlighting that remains:• on if connected to an AC outlet;• lit for 15 seconds if using batteries or during any key press sequences,• on with alert/alarm messages.When no keys are pressed for fifteen seconds, the light goes off to conserve battery power.Backlighting is resumed with any key press.In most displays, a “Therapy Identifier” Bar appears at the far left of the screen, indicating whichtherapy is running or which programming screen is being considered. This identifier also hasanother function, and that is to alert you when more text exists either above the top line or belowthe bottom line on the display screen. The identifier bar will have an arrow configuration eitherpointing up or down or both whenever there is more text, or it will appear as a squared-off blockif no further text exists.25