Curlin 4000 User Manual - Med-E-Quip Locators

Lock Setting TableThe following table illustrates which features are controlled under which lock settings:Pump OperationActiveTherapyLockOFFLock1Lock2Lock3Change Lock Settings All All settings with correct accesscodeTurn Pump Off/On All Yes Yes Yes YesPause/Run Therapy All Yes Yes Yes YesAccess Help/Options All Yes Yes Yes YesCheck Power Source All Yes Yes Yes YesResume Therapy All Yes Yes Yes YesView Rx Screens at “No to Review” All Yes Yes Yes YesRepeat Therapy All Yes Yes Yes NoPrime Pump All Yes Yes Yes NoChange Audio Level All Yes Yes Yes NoChange Rx screen information All Yes Yes No NoChange Rx screen at “No to Review” All Yes Yes No NoAccess New Program All Yes No No NoChange Air in Line Setting All Yes No No NoChange Down Pressure All Yes No No NoChange KVO RateCON, TPN, Yes Yes No NoINT, VARDelay StartCON, TPN, Yes No No NoINT, VARChange Units (New Program)CON, PCA, Yes No No NoINT, VARChange Concentration (New Program) CON, PCA, Yes No No NoINT, VARUtilize Titration Option CON, PCA Yes Yes No NoProgram Titration Limits CON, PCA Yes No No NoChange Administration Route (New Program) PCA Yes No No NoProgram Loading Dose PCA Yes No No NoProgram Clinician Dose PCA Yes No No NoAccess Early Down Ramp TPN Yes Yes Yes YesChange Next Dose Time INT Yes Yes No NoWhenever a lock setting is placed in the pump it is retained unless changed by using either theBIOMED SETUP function or the OPTIONS function to change the setting. If a locked-outfunction is requested, such as PRIME in lock setting 3, a screen will appear requesting the entry ofthe access code. When the correct code is entered, the locked out function can be performed bythe clinician.Note: The lock setting remains the same, but the pump recognizes the access code, andauthorizes the function to be performed without the need to change the lock setting.160