Curlin 4000 User Manual - Med-E-Quip Locators

This screen will continue to display as long as the infusion is running. Notice the information oneach field:1 The first field displays the “RATE” of the infusion toggled with the programmed Bolus DoseAmount. This field also displays “BOLUS xx (mg/ml/mcg)” whenever a bolus dose is beingdelivered. The programmed bolus amount displays and the BOLUS text flashes when thepump is delivering a bolus dose.2 The second field is a graphic bar representing the percentage of the completed infusion. InCMS-enabled pumps, the graphic bar will toggle with Line Pressure (“L Press”)which displays the current patient side (downstream) pressure in the administrationset in millimeter of mercury (mmHg) units.3 The third line displays the total volume “TOT Vol” infused and, if mg or mcg is the selectedunit, this field will toggle to display the total mg or mcg infused “TOT INF” as well.4 The fourth line displays the number of boluses delivered and number of boluses attemptedper bag volume. If the patient attempts a bolus before the allowed amount of time setbetween boluses, an alert message will display “Bolus Requested,” and only the secondnumber will increase. Also, toggling with number of boluses delivered/requested is theremaining volume left in the bag.5 In addition to the display screen, information on the status of the infusion is provided by thethree LED lights. The green LED light blinks whenever the pump is infusing. If the Basalrate is set at “0”, the yellow LED light will blink along with the green light until the bolus isactually being delivered. While the bolus is infusing, only the green light will blink.The information on the run screen will alternate between a four-line display and a large fontdisplay of each individual line of information on the screen.PCA PCA TherapyPCA Information Screens67