Curlin 4000 User Manual - Med-E-Quip Locators

More documents

Recommendations

Info

1 The first field displays the “RATE” of the infusion. If the therapy is in a ramp up or downphase, the rate will change accordingly to reflect the gradual increase or decrease in rate. TheRate toggles with the Volume to Be Infused.2 The second field is a graphic bar representing the percentage of the completed infusion. Italso depicts the up or down ramping phase with gradually taller or shorter lines on the bargraph. In CMS-enabled pumps, the graphic bar will toggle with Line Pressure (“LPress”) which displays the current patient side (downstream) pressure in theadministration set in millimeter of mercury (mmHg) units.3 The third field displays total volume infused.4 The fourth field displays the remaining time to the completion of the infusion. This toggleswith the remaining volume.5 In addition to the display screen accumulating information regarding the status of theinfusion, the green LED light blinks whenever the pump is infusing.The information on the run screen will alternate between a four-line display and a large-fontdisplay of each individual line of information on the screen.TPN Information ScreensInterrupting an InfusionThe infusion can be paused at any time by pressing the “PAUSE” key. The yellow “Standby”LED light blinks, and the following screen displays:Pause Menu Screen82
The screen offers the user three options:Resuming the Current Container1 RESUME: To resume the therapy in progress from where it left off, press the“YES/ENTER” key at this field. The pump will return to the Run Options Screen, and youcan resume the therapy.Note: If you wish to hang a new container, move the cursor to REPEAT Rx (see followingsection).Run Options Screena. Press the “RUN” key to resume the therapy.b. Press the “NO” key to go back to the programming screen to make changes in thetherapy program (this feature may be blocked by a security lock, thus not allowingchanges to the program unless an access code is given). Also, remember that no changesare allowed in the first prescription menu if an infusion is in progress.c. Press the “OPTIONS” or “PRIME” keys if either of these functions is desired at thistime.TPN TherapyHanging a New Container2 REPEAT Rx: To repeat the present therapy and add another IV container with the sameprescription, press the “YES/ENTER” key at this field. If more than one therapy isprogrammed, a “Select Therapy Screen” will list all preprogrammed therapies. Select whichtherapy to repeat by moving the cursor to the therapy of choice and pressing the“YES/ENTER” key.The pump will then display the program screen with the last programmed values of thetherapy and the cursor will automatically advance through the prescription menus. You canstop the auto-advance function by pressing any key (except ON/OFF) and then complete theconfirmation of the prescription manually by pressing the “YES” key at the remaining fields.When the program is accepted, the display returns to the above “Run Options Screen.” If thecurrent therapy is still in progress when the “REPEAT Rx” function is selected, the followingscreen will appear:a. This screen is a reminder that the infusion is not complete. If the therapy is to beterminated and a new IV container added, press “YES/ENTER” to go to theprogramming screen, confirm the program and proceed with the repeat infusion.83
Page 1 and 2:
CURLIN MEDICALUser’s Manualfor us
Page 3 and 4:
TABLE OF CONTENTSEntering or Changi
Page 5 and 6:
TABLE OF CONTENTSPrime.............
Page 7 and 8:
IntroductionChapter1IntroductionThe
Page 9 and 10:
• Retained memory features that a
Page 11 and 12:
CAUTIONS• U.S. federal law restri
Page 13 and 14:
• This equipment generates, uses,
Page 15 and 16:
Serial Number LabelIntroductionBatt
Page 17 and 18:
Preparing Medication for Infusion/C
Page 19 and 20:
Opening and Closing the Pump DoorTh
Page 21 and 22:
Air DetectorNote: Open theslide cla
Page 23 and 24:
Installing the Batteries and Using
Page 25 and 26:
IMPORTANTINFORMATIONWhenever an ext
Page 27 and 28:
IntroductionLocking SleeveTwo-Pin A
Page 29 and 30:
Chapter2Learning Pump FeaturesLearn
Page 31 and 32:
LED Light IndicatorsThis “three-l
Page 33 and 34:
Chapter3Basics of ProgrammingThe Cu
Page 35 and 36:
whenever an alarm or error code occ
Page 37 and 38: Access CodeClinician Access Code Sc
Page 39 and 40: to all pump functions. Each level h
Page 41 and 42: 8 PRINT PATIENT HISTORY: To print t
Page 43 and 44: a. Time Format: You have the option
Page 45 and 46: If only one therapy is programmed a
Page 47 and 48: Chapter4Continuous TherapyContinuou
Page 49 and 50: If the KVO rate is set to 0, the pu
Page 51 and 52: 6 DONE?: If any changes are to be m
Page 53 and 54: The following screen displays the C
Page 55 and 56: detects in-line pressures at 400 mm
Page 57 and 58: In CMS-enabled pumps, the graphic b
Page 59 and 60: . If the incomplete therapy is to b
Page 61 and 62: PCA TherapyChapter5PCA TherapyPCA o
Page 63 and 64: a. MxRATE (Maximum Rate) limits: Us
Page 65 and 66: using the numeric keys and, when co
Page 67 and 68: Note. After the infusion has starte
Page 69 and 70: d. To exit the shift total feature
Page 71 and 72: pressures at 400 mmHg ±150 (8 ±3
Page 73 and 74: This screen will continue to displa
Page 75 and 76: When the program is accepted, the d
Page 77: which therapy to repeat by moving t
Page 80 and 81: The time format (12 hr AM/PM or 24
Page 82 and 83: time period using the numeric keys,
Page 84 and 85: 7 To continue priming, press the PR
Page 86 and 87: Note: Whatever Down Ramp time was a
Page 90 and 91: . If the incomplete therapy is to b
Page 95 and 96: IMPORTANTINFORMATIONDuring the dela
Page 97 and 98: 10 DONE?: If there are any changes
Page 99 and 100: The following screen displays the I
Page 101 and 102: This message alerts you to the Air-
Page 103 and 104: Intermittent Information ScreensInt
Page 105 and 106: Intermittent Dosing ScheduleThe dos
Page 107 and 108: This screen displays:1 “INFUSION
Page 109 and 110: CHAPTER8Variable TherapyThis therap
Page 111 and 112: During the delay start period, if t
Page 113 and 114: 5 NEXT?: If there are any changes t
Page 115 and 116: 7 To continue priming, press the PR
Page 117 and 118: 4 DN Occlu (Down Occlusion): This f
Page 119 and 120: Variable Run Screen 2This screen di
Page 121 and 122: stop the auto-advance function by p
Page 123 and 124: The pump will then display the prog
Page 125 and 126: TroubleshootingChapter9Troubleshoot
Page 127 and 128: LCD Display:Alert:Cause:Resolution:
Page 129 and 130: If it is not necessary to preserve
Page 131 and 132: Resolution:LCD Display:Alert:Cause:
Page 133 and 134: LCD Display: ALERT NEW DOSE IS LESS
Page 135 and 136: LCD Display:Alert:Cause:Resolution:
Page 137 and 138: ALARMSAlarms are conditions that re
Page 139 and 140:
LCD Display:Alarm:Cause:Resolution:
Page 141 and 142:
ERROR CODESIf a pump goes into an e
Page 143 and 144:
ErrorCodeLCD DisplayedMessage162 St
Page 145 and 146:
ChapterAccessories10There are a num
Page 147 and 148:
AccessoriesFigure 10.3 Safety Shell
Page 149 and 150:
Keypad CoversThese accessories are
Page 151 and 152:
Chapter11Cleaning, EnvironmentalCon
Page 153 and 154:
1 PARTIES COVERED BY THIS WARRANTY:
Page 155 and 156:
d Program the following CONTINUOUS
Page 157 and 158:
Chapter12TechnicalSpecificationsThe
Page 159 and 160:
ITEMDown Occlusion Detection TimeMi
Page 161 and 162:
Curlin pump inusing at .1 ml/hr w i
Page 163 and 164:
Percent Error, Curlin Pump infusing
Page 165 and 166:
Clinician Information andAccess Cod
show all

Curlin 4000 User Manual - Med-E-Quip Locators

Create successful ePaper yourself

Delete template?

Save as template?