Curlin 4000 User Manual - Med-E-Quip Locators

e delayed until a later time, press the “NO/CHANGE” key. The delay start will changefrom “OFF” to “ON”. Press the “YES/ENTER” to accept and the following screen willappear:Continuous Delay Start SettingThe time format (12 hr AM/PM or 24 hr Military) selected in the BIOMED SETUP Menuwill apply in this table; and, if Military was selected, the AM/PM field will not appear here. Ifthe entire delay start screen is to be aborted, press the “NO” key at the ACCEPT field. Whenthe start time and date are entered and the data is accepted after the “YES/ENTER” key ispressed, the infusion is set to start at the programmed time. The display then returns to thenext field in the Pre-Prescription Menu.After the entire prescription program is accepted, if the pump is turned OFF and back ON,press “YES” at PROGRAM and “YES” to REPEAT Rx. The cursor will automaticallyscroll through the program. No changes will be allowed in the Pre-Prescription Menu duringthis time, thus maintaining the originally programmed Delay Start time. To change the DelayStart time, press the “NO/CHANGE” key when the Run Options Screen is displayed:Run Options ScreenThis will allow the clinician to go back to review the program and at this point a change canbe made to the delay start time.Note: If the pump is not connected to the patient’s access site at this time, the patient orcaregiver should be taught proper techniques to access the infusion site before thescheduled start time.When the “”RUN” key is pressed, the Green and Yellow LED lights will flash to indicate thatthe pump will automatically start when the delay start countdown period is up. During thedelay start time, the following screen appears:42