Multilin 469 Motor Management Relay ... - GE Digital Energy

CHAPTER 4: INTERFACES
4.3.4 Connecting to the Relay
Select “Ethernet” from the Interface drop-down list.
This will display a number of interface parameters that must be
entered for proper Ethernet functionality.
Enter the IP address assigned to the relay.
Enter the slave address and Modbus port values (from the S1 469
SETUP SERIAL PORTS menu) in the Slave Address and Modbus
Port fields. Refer to GEK-106491C: 469 Communications Guide.
Click the Read Order Code button to connect to the 469 device and
upload the order code.
If a communications error occurs, ensure that the 469 Ethernet
communications values entered in the previous step correspond to
the relay setting values.
Click OK when the relay order code has been received.
The new device will be added to the Site List window (or Online
window) located in the top left corner of the main EnerVista 469
Setup window.
The 469 Site Device has now been configured for Ethernet communications. Proceed to the
following section to begin communications.
Now that the communications parameters have been properly configured, the user can
easily connect to the relay.
Expand the Site list by double clicking on the site name or clicking on
the «+» box to list the available devices for the given site (for
example, in the “Pumping Station 1” site shown below).
469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL 4–19