Multilin 469 Motor Management Relay ... - GE Digital Energy

CHAPTER 4: INTERFACES
Click OK.
The process for File > Print Preview Settings is identical to the steps above.
Settings lists can be printed in the same manner by right clicking on the desired file (in the
file list) or device (in the device list) and selecting the Print Device Information or Print
Settings File options.
A complete list of actual values can also be printed from a connected device with the
following procedure:
Establish communications with the desired 469 device.
From the main window, select the File > Print Settings menu item.
The Print/Export Options dialog box will appear.
Select Actual Values in the upper section.
Select either Include All Features (for a complete list) or Include Only
Enabled Features (for a list of only those features which are
currently used) in the filtering section.
Click OK.
Actual values lists can be printed in the same manner by right clicking on the desired
device (in the device list) and selecting the Print Device Information option.
Loading Settings from a File
An error message will occur when attempting to download a Settings file with a
revision number that does not match the relay firmware. If the firmware has been
upgraded since saving the Settings file, see Upgrading Settings Files to a New Revision
on page 4–31 for instructions on changing the revision number of a Settings file.
The following procedure illustrates how to load settings from a file. Before loading a
Settings file, it must first be added to the EnerVista 469 Setup environment as described in
Adding Settings Files to the Environment on page 4–24.
Select the previously saved Settings file from the File pane of the
EnerVista 469 Setup software main window.
Select the File > Properties menu item and verify that the
corresponding file is fully compatible with the hardware and
firmware version of the target relay.
If the versions are not identical, see Upgrading Settings Files to a New
469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL 4–33