final bid specs 09328.pdf - Freese and Nichols, Inc.

ACCEPTABLE MANUFACTURERS
ProVent Systems, Inc. ProSet Trap Guard. 800.262.5355
or
www.trapguard.com
CC. HOSE BIBBS
1. Hose bibb (HB): Chrome plated brass, provided with wall flange, 1/2" female N.P.T. inlet
by 3/4" male N.H.T. outlet, with chrome plated vacuum breaker in conformance with
ANSI/ASSE 1011.
ACCEPTABLE MANUFACTURERS AND MODELS
Chicago Faucet 15-E27 or 7-E27
T&S Brass
B-702-B-972
Royal Brass
5115-136-G
Woodford
24P
DD. WALL HYDRANTS
1. Non-freeze wall hydrant (NFWH): ANSI/ASSE 1019; exposed wall hydrant type, with
chrome plated brass or nickel bronze finish on brass castings, freezeless, 3/4" hose
thread nozzle, integral vacuum breaker, and loose key handle.
ACCEPTABLE MANUFACTURERS AND MODELS
Woodford 65
Josam 71050
Jay R. Smith 5609
Wade W-8620
Zurn Z-1310
EE. HEAT TRACING SYSTEMS
1. Freeze Protection System
a. Heat tracing: Automatic self-regulating, UL listed, with tinned copper braid, able to
crossover itself without overheating, parallel circuit design, able to be cut to length at
job site, flat and flexible for easy installation, corrosion and chemical resistant,
complete with power connection kits, splice kits, tee kits, end seal kits and necessary
accessories for a complete operating installation. Provide pipe insulation for all
piping requiring heat tracing. Verify with the heat trace manufacturer that the
temperature rating of the piping will handle the heat trace temperature provided.
ACCEPTABLE MANUFACTURERS
Hevi-Duty/Nelson
Raychem
Thermon
b. Hot Water Temperature Maintenance System
Heat tracing: Automatic self-regulating, UL listed, with tinned copper braid, able to
crossover itself without overheating, parallel circuit design, able to be cut to length at
job site, flat and flexible for easy installation and corrosion and chemical resistant.
Heat tracing shall maintain hot water temperature at 105°F. Heat tracing shall be
complete with power connection kits, splice kits, tee kits, end seal kits and necessary
accessories for a complete operating installation. Install per manufacturers
instructions. Provide pipe insulation for all piping requiring heat tracing. Verify with
the heat trace manufacturer that the temperature rating of the piping will handle the
heat trace temperature provided.
Plumbing Systems 22 00 01 - 11
DPR09328