final bid specs 09328.pdf - Freese and Nichols, Inc.

26 24 16 LIGHTING AND BRANCH PANELBOARDS
1.00 GENERAL
1.01 WORK INCLUDED
Furnish labor, materials, equipment and incidentals necessary to install lighting and branch
panelboards. Electrical work shall be in accordance with Section 26 05 00, COMMON WORK
RESULTS FOR ELECTRICAL.
1.02 QUALITY ASSURANCE - ACCEPTABLE MANUFACTURERS
Panelboards shall comply with the specifications and shall be by the following Manufacturers:
A. General Electric
B. Eaton Cutler-Hammer
C. Square D
1.03 SUBMITTALS
Submittals shall be in accordance with Section 01 33 00, SUBMITTALS and shall include:
A. Shop Drawings:
a. Bill of Material
b. Front Elevation with dimensions
c. Assembly ratings including short circuit ratings, continuous current and voltage
d. Cable terminal sizes
e. Cut sheet on circuit breakers
1.04 STANDARDS
Circuit breakers, molded case, and branch circuit shall be in accordance with the applicable
provisions of the following standards as if written here in their entirety:
A. Fed. Spec. W-C-375
B. NEMA AB1 Molded Case Circuit Breakers and their application.
C. NEMA PB1 Panelboards
1.05 DELIVERY AND STORAGE
Equipment shall be handled and stored in accordance with the manufacturer’s instructions.
Equipment shall be protected from damage.
1.06 WARRANTY
The manufacturer shall warrant the equipment to be free from defects.
1.07 QUALITY ASSURANCE
A. Manufacturer shall be ISO 9001 2000 or later certified.
Lighting and Branch Panelboards 26 24 16-1
DRP09328