final bid specs 09328.pdf - Freese and Nichols, Inc.

26 29 13 ENCLOSED CONTROLLERS
1.00 GENERAL
1.01 WORK INCLLUDED
A. Furnish labor, materials, equipment and incidentals to install combination motor starters.
Electrical work shall be in accordance with Section 26 05 00, COMMON WORK RESULTS
FOR ELECTRICAL. Section includes the following enclosed controllers rated 600 V and less:
1.02 QUALITY ASSURANCE - ACCEPTABLE MANUFACTURERS
A. Enclosed Controllers shall comply with the specifications and shall be by the following Manufacturers:
1. Allen Bradley
2. Eaton Cutler-Hammer
3. General Electric
4. Square D
1.03 QUALITY ASSURANCE
A. Electrical Components, Devices, and Accessories: Listed and labeled as defined in and
marked for intended location and application.
B. Comply with NFPA 70.
C. Coordinate with equipment suppliers for actual motor data – HP, voltage, amps, etc, to properly
size controller (starter) and overloads.
1.04 SUBMITTALS
Submittals shall be in accordance with Section 01 33 00, SUBMITTALS and shall include:
A. Shop Drawings: For each enclosed controller.
1. Include dimensioned plans, elevations, sections, details, and required clearances and
service spaces around controller enclosures.
2. Include manufacturer's technical data on features, performance, electrical characteristics,
ratings, and enclosure types and finishes. Data sheets shall clearly identify the make and
model number of the equipment being provided.
3. Show tabulations of the following:
a. Each installed unit's type and details.
b. Factory-installed devices.
c. Nameplate legends.
d. Short-circuit current rating of integrated unit.
e. Features, characteristics, ratings, and factory settings of individual overcurrent
protective devices in combination controllers.
f. Project specific wiring diagrams/control schematics: For power, signal, and control
wiring.
Enclosed Controllers 26 29 13 - 1
DRP09328