final bid specs 09328.pdf - Freese and Nichols, Inc.

E. Unless other additional information is required by the detailed equipment specifications, the
following information shall be included for motors:
1.04 STANDARDS
1. Motor identification number and nomenclature as specified
2. Make and motor type
3. Brake horsepower of the motor
4. Locked rotor current at full load
5. Motor efficiency at full load (3-phase motors only)
6. Starting torque
7. Method of insulating and impregnating motor coils (3-phase only)
8. Speed of the motor at full torque
9. Full load current
10. Service factor
11. Motor temperature rise measured by resistance over 40 degrees C ambient
A. Electrical work shall be executed in accordance with local, State and national codes,
ordinances and regulations which have jurisdiction or authority over the work. If the standards
and codes conflict with each other, the most stringent shall apply. The applicable provisions
of the following standard shall apply as if written here in their entirety:
National Electrical Manufacturer Association (NEMA)
American Society for Testing and Materials (ASTM)
National Fire Protection Association (NFPA)
National Electrical Safety Code (NESC)
Institute of Electrical and Electronic Engineers (IEEE)
National Electrical Code (NEC)
Underwriters' Laboratories (UL)
American National Standards Institute (ANSI)
Uniform Building Code (UBC)
Occupational Safety and Health Administration (OSHA)
Local utility companies
Local Electrical Ordinance
Rural Electrification Association (REA)
Insulated Power Cable Engineers Association (IPCEA)
International Electrical Testing Association (NETA)
National Electrical Contractors Association (NECA)
Association Edison Illuminating Companies (AEIC)
B. Electrical work shall be performed under the direct supervision of a Master Electrician who
holds a valid license in the State of Texas.
Common Work Results for Electrical 26 05 00-2
DRP09328