final bid specs 09328.pdf - Freese and Nichols, Inc.

D. LAMPS
1. FLUORESCENT: Cool white; rapid start, unless otherwise specified or indicated.
2. METAL HALIDE: Phosphor-coated, unless otherwise specified or indicated; selfextinguishing
type when the outer lamp envelope is broken.
E. EXIT LIGHTS: Single or double face unit as required for each location, with arrows to clearly
define the path of egress and which flash at a rate not exceeding five (5) hertz. Provide
battery-powered exit lights if the exits lights are not served with an emergency power source.
3.00 EXECUTION
3.01 INSTALLATION
A. Provide the lighting fixtures, as specified and scheduled on the plans. If a type designation is
omitted, verify the fixture selection with the ENGINEER before installation.
B. Check the architectural finishes and provide fixtures with proper trim, frames, support hangers
and other hardware required to coordinate with the proper finishes, regardless of the specified
or scheduled catalog number, prefixes and suffixes.
C. Fixtures which are tandem-mounted and recessed in gypboard or plaster ceilings shall be
yoke-mounted.
D. Test and aim flood lights, when dark outside to provide a uniform and widespread, illuminated
area. Direct units as indicated or instructed by the ENGINEER to prevent objectionable glare.
E. Furnish and install photocells where indicated on the plans. Cells shall face a northerly
direction.
F. Furnish and install exit lights where scheduled and indicated on the plans. Locate fixtures on
the ceiling or wall, as required by the ENGINEER. Provide relays and the necessary wiring to
provide a flashing exit light system upon the activation of a fire alarm. Install exit lights in
accordance with Paragraph (Q)(2) of the Handicapped Accessibility Act of Texas.
G. Furnish and install a complete exterior lighting control system, as indicated on the plans.
Provide materials and equipment to properly interface timing devices and photocells with
relays and contactors so that a complete and satisfactory operating system is rendered.
3.02 CLEAN AND ADJUST
Immediately before final inspection, clean all fixtures, inside and out, including plastics and
glassware. Adjust all trim to properly fit adjacent surfaces. Replace broken or damaged parts.
Lamp and test all fixtures for electrical, as well as, mechanical operation.
END OF SECTION
Lighting 26 50 00-2
DRP09328