final bid specs 09328.pdf - Freese and Nichols, Inc.

26 27 26 WIRING DEVICES
1.00 GENERAL
1.01 WORK INCLUDED
Furnish labor, materials, equipment and incidentals necessary to install wiring devices. Electrical
work shall be in accordance with Section 26 05 00, COMMON WORK RESULTS FOR
ELECTRICAL.
1.02 QUALITY ASSURANCE - ACCEPTABLE MANUFACTURERS
A. Source Limitations: Obtain each type of wiring device and associated wall plate through one
source from a single manufacturer. Insofar as they are available, obtain all wiring devices and
associated wall plates from a single manufacturer and one source.
B. Electrical Components, Devices, and Accessories: Listed and labeled as defined in NFPA 70,
Article 100, by a testing agency acceptable to authorities having jurisdiction, and marked for
intended use.
C. Comply with NFPA 70.
D. Products shall comply with the specifications and shall be by the following Manufacturers:
1. Hubbell
2. Leviton
3. Pass & Seymour
1.03 SUBMITTALS
Submittals shall be in accordance with Section 01 33 00, SUBMITTALS and shall include:
A. Shop Drawings for Wiring Devices: Cut sheets of all devices indicating model being provided,
NEMA configuration, rating, color, etc.
1.04 STANDARDS
The applicable provisions of the following standard shall apply as if written here in its entirety:
NEMA WD-1
NEMA WD-6
UL 943
NFPA 70
General Color Requirements for Wiring Devices
Wiring Devices – Dimensional Requirements
Ground-Fault Circuit-Interrupters
National Electrical Code
Wiring Devices 26 27 26-1
DRP09328