final bid specs 09328.pdf - Freese and Nichols, Inc.

g. Project specific layout of front of controller clearly indentifying the location of all panel
mounted devices.
h. Terminal strip layout clearly showing all field connections.
B. OPERATION AND MAINTENANCE MANUALS:
1. Operation and maintenance manuals shall contain the shop drawings, submittals, spare
parts lists, schematics, and maintenance procedures.
2. Manuals shall also incorporate appropriate final certified shop drawings. Manuals may
be manufacturer's standard instructions, but shall be supplemented as necessary to
cover any special feature not included in standard material.
3. Manufacturer's written instructions for testing, adjusting, and reprogramming reducedvoltage
solid-state controllers.
C. Load-Current and Overload-Relay Heater List: Compile after motors have been installed,
and arrange to demonstrate that selection of heaters suits actual motor nameplate full-load
currents.
D. Load-Current and List of Settings of Adjustable Overload Relays: Compile after motors have
been installed, and arrange to demonstrate that switch settings for motor running overload
protection suit actual motors to be protected.
1.05 DELIVERY, STORAGE, AND HANDLING
A. Store enclosed controllers indoors in clean, dry space with uniform temperature to prevent
condensation. Protect enclosed controllers from exposure to dirt, fumes, water, corrosive
substances, and physical damage.
B. If stored in areas subject to weather, cover enclosed controllers to protect them from weather,
dirt, dust, corrosive substances, and physical damage. Remove loose packing and flammable
materials from inside controllers.
1.06 PROJECT CONDITIONS
A. Environmental Limitations: Rate equipment for continuous operation under the following
conditions unless otherwise indicated:
1. Ambient Temperature: Not less than minus 22 deg F (minus 30 deg C) and not
exceeding 122 deg F (50 deg C).
2. Altitude: Not exceeding 3300 feet.
B. HORSEPOWER RATING: Horsepowers as indicated on the Plans are approximate. The
Contractor shall furnish properly sized motor control equipment when actual motor horsepowers
are determined. If actual motor horsepowers differ from the Plans, the Contractor
shall obtain assistance from the Engineer in determining whether or not hardware and wiring
changes are necessary. The Contractor shall provide all components and wire of the proper
size.
C. OPERATING VOLTAGE: The equipment shall be designed and arranged for operation on
208 Volt, 3 phase, 60 Hertz or 120V, 60 Hertz. See plans for more details.
Enclosed Controllers 26 29 13 - 2
DRP09328