final bid specs 09328.pdf - Freese and Nichols, Inc.

B. Chain-Hoist Operator: Provide manual chain-hoist operator consisting of endless steel hand
chain, chain pocket wheel and guard, and gear-reduction unit with a maximum 35-lbf (155-N)
force for door operation. Provide alloy steel hand chain with chain holder secured to operator
guide.
2.06 FINISHES, GENERAL
A. General: Comply with NAAMM's "Metal Finishes Manual for Architectural and Metal Products"
for recommendations for applying and designating finishes.
B. Appearance of Finished Work: Variations in appearance of abutting or adjacent pieces are
acceptable if they are within one-half of the range of approved Samples. Noticeable variations
in the same piece are not acceptable. Variations in appearance of other components
are acceptable if they are within the range of approved Samples and are assembled or installed
to minimize contrast.
2.07 ALUMINUM FINISHES
A. Finish designations prefixed by AA comply with the system established by the Aluminum Association
for designating aluminum finishes.
B. Powder-Coat Finish: Manufacturer's standard powder-coat finish consisting of primer and
topcoat according to coating manufacturer's written instructions for cleaning, pretreatment,
application, thermosetting, and minimum dry film thickness.
3.00 EXECUTION
3.01 INSTALLATION
1. Color and Gloss: As selected by Architect from manufacturer's full range.
A. General: Install coiling doors and operating equipment complete with necessary hardware,
jamb and head molding strips, anchors, inserts, hangers, and equipment supports.
3.02 ADJUSTING
A. Lubricate bearings and sliding parts; adjust doors to operate easily, free of warp, twist, or distortion
and with weathertight fit around entire perimeter.
3.03 STARTUP SERVICES
A. Engage a factory-authorized service representative to perform startup service.
1. Complete installation and startup checks according to manufacturer's written instructions.
2. Test and adjust controls and safeties. Replace damaged and malfunctioning controls
and equipment.
3.04 DEMONSTRATION
A. Engage a factory-authorized service representative to train Owner's maintenance personnel
to adjust, operate, and maintain overhead coiling doors.
END OF SECTION
Overhead Coiling Doors 08 33 23 - 4
DPR09328