TROLL 9500 Operator's Manual - Geotech Environmental Equipment

Section 3: Getting StartedSet Up to Log Data (Set Up a Test)A “test” is a set of instructions to the instrument’s internal data loggerfor collecting a set of data—including which parameters to measure,how often, and when to start. Section 6 below contains detailed informationon setting up tests.1. With the MP TROLL 9500 connected to a host PC, click or tapTests in the Navigation tree.2. Click or tap Add....Complete the SetupIf real-time readings are not required, remove the TROLL Com fromthe cable after programming.Protect the “uphole” end of the cable with the cable dust cap or desiccant.The cable dust cap is not waterproof. Be sure it ispositioned above the highest anticipated water level. Avoidareas that may flood.If cable will not be used, attach a Twist-Lock Hanger to the TROLL9500.The instrument is now ready for transport to the site where it will beused to take measurements.12The Test Wizard will help you enter the information. The choicesare discussed in detail in Section 6 below.3. When you finish the Wizard, Win-Situ sends the information to thedevice and updates the display.If you added “scheduled” test (indicated by in the Navigationtree), it will start at its programmed time.If you set up a test or a manual start (indicated by in the Navigationtree), you can start it at any time by pressing the Start buttonwhile connected in software.TIP: For complete information on setting up tests, refer toSection 7 of this operator’s manual.TROLL 9500 Operator’s Manual21 0095110 rev. 007 01/09