TROLL 9500 Operator's Manual - Geotech Environmental Equipment

Section 4: Control SoftwareLogging Data (Adding a Test)Logging data with the MP TROLL 9500 is called “running a test.” Totell the instrument how to run the test—which parameters to measure,how often, when to start, etc.—you “add” a test to the device.TIP: For more on logging, extracting, viewing, and deletingdata, refer to Section 6.1. With the MP TROLL 9500 connected to a host PC and selected inthe Navigation tree, click or tap Tests.2. Click or tap Add....Taking “Manual” ReadingsThe MP TROLL 9500 collects data in “tests” but you can get a quick“manual” reading from any device apart from a test, even while a testis running.1. With the MP TROLL 9500 connected to a host PC and selected inthe Navigation tree, click or tap Parameters.2. In the Information pane, select one or more parameters to read. Toselect multiple parameters, hold the Control key while selecting.(To display the CTRL key on a PDA, tap the keyboard symbol inthe Command bar.)12123The Test Wizard starts. See Section 6 for a description of the elementsthat constitute a complete test definition.3. When you finish the Wizard, the information is sent to the deviceand the display is updated.3. Click or tap Read.TIP: For continuously updated real-time “manual” readingsof all parameters, select Profiler in the Information pane.Refer to Section 5 for Profiler information.TROLL 9500 Operator’s Manual29 0095110 rev. 007 01/09