FMS - GAIL

61 Drawings to be supplied by
the employer
62 Drawings to be supplied by
the contractor:
be valid).
b) Beyond (-) 25% upto & For reduction beyond 25%
inclusive of (-) 50% contractor shall be
compensated by an amount
equivalent to 10% of the
reduction in value of the
contract as awarded. For
example if the actual contract
value is 70% of awarded value
then compensation shall be
10% of (75-70) i.e. 0.5% of
awarded contract value.
II. For Lumpsum Contracts
CONTRACTOR shall, within 7 days of the date of receipt
of order to carry out the WORK, inform the
ENGINEER-IN- CHARGE of the rates which it is his
intention to charge for such class of WORK, supported by
analysis of the rate or rates claimed, and the
ENGINEER-IN-CHARGE shall determine the rate or
rates on the basis of the prevailing market rates, labour
cost at schedule of labour rates plus 10% to cover
contractor's supervision, overheads and profit and pay
the CONTRACTOR accordingly. The opinion of the
ENGINEER- IN-CHARGE as to current market rates of
materials and the quantum of labour involved per unit of
measurement will be final and binding on the
CONTRACTOR.
61.1 The drawings attached with tender are only for the general
guidance to the CONTRACTOR to enable him to visualize the type
of work contemplated and scope of work involved. The
CONTRACTOR will be deemed to have studied the DRAWINGS
and formed an idea about the WORK involved.
61.2 Detailed working drawings on the basis of which actual execution of
the WORK is to proceed, will be furnished from time to time during
the progress of the work. The CONTRACTOR shall be deemed to
have gone through the DRAWINGS supplied to him thoroughly and
carefully and in conjunction with all other connected drawings and
bring to the notice of the ENGINEER-IN-CHARGE discrepancies, if
any, therein before actually carrying out the Work.
61.3 Copies of all detailed working drawings relating to the WORK shall
be kept at the CONTRACTOR's office on the site and shall be made
available to the ENGINEER-IN- CHARGE at any time during the
CONTRACT. The drawings and other documents issued by the
EMPLOYER shall be returned to the EMPLOYER on completion of
the WORK.
62.1 The drawings/date which are to be furnished by the CONTRACTOR
are enumerated in the special conditions of contract, and shall be
furnished within the specified time.
62.2 Where approval/review of drawings before manufacture/
construction/fabrication has been specified, it shall be
CONTRACTOR's responsibility to have these drawings prepared as
per the directions of ENGINEER-IN-CHARGE and got approved
before proceeding with manufacture/construction/fabrication as the
81