FMS - GAIL

63
Setting out works:
case may be. Any change that may have become necessary in
these drawings during the execution of the work shall have to be
carried out by the CONTRACTOR to the satisfaction of
ENGINEER-IN-CHARGE at no extra cost. All final drawings shall
bear the certification stamp as indicated below duly signed by both
the CONTRACTOR and ENGINEER-IN-CHARGE.
"Certified true for ___________________________________
(Name of Work)
Agreement
No.___________________________________________________
Signed:_________________ _________________
(CONTRACTOR) (ENGINEER-IN-CHARGE)
62.3 The DRAWINGS submitted by the CONTRACTOR shall be
reviewed by the ENGINEER-IN-CHARGE as far as practicable
within 3 (Three) weeks and shall be modified by the
CONTRACTOR, if any modifications and/or corrections are required
by the ENGINEER-IN-CHARGE. The CONTRACTOR shall
incorporate such modifications and/or corrections and submit the
final drawings for approval. Any delays arising out of failure by the
CONTRACTOR to rectify the drawing in good time shall not alter
the Contract Completion Time.
62.4 As built drawings showing all corrections, adjustments etc. shall be
furnished by the CONTRACTOR in six copies and one transparent
for record purposed to the EMPLOYER.
63.1 The ENGINEER-IN-CHARGE shall furnish the CONTRACTOR with
only the four corners of the Works site and a level bench mark and
the CONTRACTOR shall set out the Works and shall provide an
efficient staff for the purpose and shall be solely responsible for the
accuracy of such setting out.
63.2 The CONTRACTOR shall provide, fix and be responsible for the
maintenance of all stakes, templates, level marks, profiles and other
similar things and shall take all necessary precautions to prevent
their removal or disturbance and shall be responsible for the
consequence of such removal or disturbance should the same take
place and for their efficient and timely reinstatement. The
CONTRACTOR shall also be responsible for the maintenance of all
existing survey marks, boundary marks, distance marks and center
line marks, either existing or supplied and fixed by the
CONTRACTOR. The work shall be set out to the satisfaction of the
ENGINEER-IN-CHARGE. The approval there of joining with the
CONTRACTOR by the ENGINEER- IN-CHARGE in setting out the
work, shall not relieve the CONTRACTOR of any of his
responsibility.
63.3 Before beginning the Works, the CONTRACTOR shall at his own
cost, provide all necessary reference and level posts, pegs,
bamboos, flags, ranging rods, strings and other materials for proper
layout of the works in accordance with the schemes for bearing
marks acceptable to the ENGINEER-IN-CHARGE. The center,
longitudinal or face lines and cross lines shall be marked by means
of small masonry pillars. Each pillar shall have distinct mark at the
centre to enable theodolite to be set over it. No work shall be
started until all these points are checked and approved by the
ENGINEER-IN-CHARGE in writing but such approval shall not
82