R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Graphical User Interface
Baseband Block
The Multi Carrier CW signal is only computed when the "Accept" button is pressed.
Whenever the table contains settings that have not yet been adopted with the "Accept"
button, the background is yellow.
Note: The phase/deg settings are only valid if optimization of the crest factor is disabled
("Optimize Crest Factor" = Off).
"No."
"State"
"Power"
"Phase"
"Accept"
This is the carrier index.
Switch a carrier on/off
Sets the power of a carrier.
Sets the starting phase of a carrier.
Transfer the settings in the carrier table into the instrument.
Remote command:
​[:​SOURce]:​BB:​MCCW:​CARRier:​LIST:​STATe​ on page 277
​[:​SOURce]:​BB:​MCCW:​CARRier:​STATe​ on page 279
​[:​SOURce]:​BB:​MCCW:​CARRier:​LIST:​POWer​ on page 277
​[:​SOURce]:​BB:​MCCW:​CARRier:​POWer​ on page 278
​[:​SOURce]:​BB:​MCCW:​CARRier:​LIST:​PHASe​ on page 276
​[:​SOURce]:​BB:​MCCW:​CARRier:​PHASe​ on page 278
Carrier Graph
Calls a graphical representation of the chosen carrier configuration.
The carriers are on the X-axis and the colored bars represent those carriers which are in
the On state. Power is on the Y-axis, and the height of the bars corresponds to the chosen
power of each individual carrier.
Remote command:
n.a.
Software Manual 1008.0858.42 ─ 10
90