R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Graphical User Interface
Baseband Block
"Peak"
The individual carriers are leveled based on their peak power and the
configured "Carrier Gain".
Example:
A multi carrier signal is composed from two waveform files.
First carrier "Gain" = 0 dB
Second carrier "Gain" = -3 dB
In the resulting multi carrier signal, the peak power of the second carrier
signal will be 3 dB lower than the peak power of the first carrier signal.
Example: Multi carrier signal composed of waveforms with different
crest factor
A multi carrier signal is composed from two waveform files with the following
characteristics:
3GPP FDD signals with the same "Sample Rate" but different "Crest
Factors".
"Peak" = 0 dBFS
"Carrier Gain" = 0 dB
The Peak values of the carrier signals are equal, the RMS values are
different.
Remote command:
​[:​SOURce]:​BB:​ARBitrary:​MCARrier:​POWer:​REFerence​ on page 214
Carrier Table
Calls the table for configuring individual carriers. A selectable carrier range can be set
with the aid of the optional "Carrier Table Assistant" (see ​chapter 5.10.4.4, "Muti Carrier
Table", on page 100).
The multi carrier configuration can be checked with the aid of the "Carrier Graph".
Software Manual 1008.0858.42 ─ 10
98