R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Remote Control Commands
SOURce:BB:DM Subsystem
Signal Order Decimal value of bits
Marker 1
Marker 2
LSBit 1
2
Burst = LSBit 16
LevAtt1 LSBit 32
CWMod LSBit 64
Hop MSBit 128
The data can also be sent as a binary block, each binary block being a 2-byte value in
which the 16 bits represent the binary values (16-bit unsigned integer, 2 bytes, LSByte
first). When binary data transmission is in use, command
:SYSTem:COMMunicate:GPIB:LTERminator EOI should be used to set the
termination character mode to ‘EOI control data message only’ so that a random LF in
the data sequence is not interpreted as End, thereby prematurely terminating the data
transmission. The command ...LTER STANdard resets the mode.
For query purposes, the command :FORMat ASCii | PACKed can be used to switch
between the formats. The byte sequence is defined in the IEC bus standard as 'most
significant byte first'
Note: C-Lists are created in binary format. However, if you need the C-List in ASCII
format, e.g. for creating a waveform file with R&S WinIQSIM2, see the example in ​chapter
7.2.3, "Creating an ASCII C-List Manually", on page 184.
*RST has no effect on data lists. This command is without query.
Setting parameters:
Example:
Usage:
string
BB:DM:CLIS:SEL 'c_list1'
selects the control list.
BB:DM:CLIS:DATA 0,0,0,0,8,8,8,0,0,0,0...
enters the control values in list c_list1. In the example, only ramps
for marker 4 are set.
Setting only
Manual operation: See "Edit Control List" on page 78
[:SOURce]:BB:DM:CLISt:DELete
The command deletes the specified control list from the default directory. The default
directory is set using command MMEM:CDIRectory. A path can also be specified, in
which case the files in the specified directory are deleted. The file extension may be
omitted. Only files with the file extension *.dm_iqc will be deleted.
Setting parameters:
Software Manual 1008.0858.42 ─ 10
253