R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Graphical User Interface
Baseband Block
Note: This function is not affected by the "Preset" function.
Remote command:
​[:​SOURce]:​BB:​DM:​SETTing:​STORe:​FAST​ on page 261
​[:​SOURce]:​BB:​ARBitrary:​MCARrier:​SETTing:​STORe:​FAST​ on page 223
refer to the description of frimware options for the syntax of the corresponding SCPI
commands
Data Source
The data source is selected and set in the "Data Source" section. The parameters offered
depend on the data source selected. The More button opens a submenu for calling the
data editor and the file manager.
Data Source - Digital Modulation
Selects the data source (see ​chapter 5.10.1, "Data and Signal Sources in Baseband",
on page 48).
You may choose from the following data sources:
"All 0, All 1"
"PRBS, PRBS
Type"
0 data or 1 data is internally generated.
PRBS data in accordance with the IUT-T with period lengths between
29-1 and 223-1 are internally generated.
The length is selected in the "PRBS Type" input box.
Remote command:
​[:​SOURce]:​BB:​DM:​PRBS[:​LENGth]​ on page 234
"Pattern"
A user-definable bit pattern with a maximum length of 64 bits is internally
generated.
The bit pattern is defined in the "Pattern" input box.
"Data List ...,
Select Data"
Data lists will be used.
Data lists can be generated internally in the data editor or externally.
Data lists are selected in the "File Select" window, which is called by
means of the "Select Data" button.
The "File" "Manager" is used to transmit external data lists to the R&S
Signal Generator, and can be called within every "File" Select window
by means of the "File" "Manager" button.
Remote command:
​[:​SOURce]:​BB:​DM:​DLISt:​SELect​ on page 257
Remote command:
​[:​SOURce]:​BB:​DM:​SOURce​ on page 235
Software Manual 1008.0858.42 ─ 10
66