R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Remote Control Commands
SOURce:BB:DM Subsystem
Example:
BB:DM:DLIS:SEL ' d_list2'
selects data list d_list2.
FORM ASC
selects ASCII data transmission format.
BB:DM:DLIS:DATA:APP 1,1,1,0,0,0,1,1,0,1...
adds the specified numeric data to the existing data in data list
d_list2.
Usage:
Setting only
Manual operation: See "Data List Editor" on page 75
[:SOURce]:BB:DM:DLISt:DELete
The command deletes the specified data list. from the default directory. The default
directory is set using command MMEM:CDIRectory. A path can also be specified, in
which case the files in the specified directory are deleted. The file extension may be
omitted. Only files with the file extension *.dm_iqd will be deleted.
Setting parameters:
Example:
Usage:
string
BB:DM:DLIS:DEL ' d_list2'
deletes data list d_list2.
Setting only
Manual operation: See "File Manager - Digital Modulation" on page 75
[:SOURce]:BB:DM:DLISt:POINts
The command defines the number of bits in the selected data list to be utilized. When a
list is being filled with block data, this data is only ever sent in multiples of 8 bits. However
the exact number of bits to be exploited can be set to a different figure. The superfluous
bits in the list are then ignored.
Parameters:
integer
Range: 0 to INT_MAX
Increment: 1
*RST: 0
Example: BB:DM:DLIS:POIN 234
defines the number of bits in the data list to be utilized as 234 bits.
If the list was filled with block data, at least the last 6 bits will be
ignored.
Software Manual 1008.0858.42 ─ 10
256