R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Remote Control Commands
SOURce:BB:DM Subsystem
[:SOURce]:BB:DM:FILTer:ILENgth
The command sets the impulse length (number of filter tabs).
Parameters:
integer
Range: 1 to 128
Increment: 1
*RST: 10
Example: BB:DM:FILT:ILEN 10
sets the number of filter tabs to 10.
Manual operation: See "Impulse Length - Digital Modulation" on page 72
[:SOURce]:BB:DM:FILTer:ILENgth:AUTO
The command activates/deactivates the impulse length state. If activated, the most sensible
parameter values are selected. The value depends on the coherence check.
Parameters:
Example:
0 | 1 | OFF | ON
*RST: 1
BB:DM:FILT:ILEN:AUTO ON
The most sensible parameters are selected automatically.
Manual operation: See "Impulse Length - Digital Modulation" on page 72
[:SOURce]:BB:DM:FILTer:OSAMpling
The command sets the upsampling factor.
Parameters:
integer
Range: 1 to 32
Increment: 1
*RST: 32
Example: BB:DM:FILT:OSAM 32
sets the upsampling factor to 32.
Manual operation: See "Oversampling - Digital Modulation" on page 72
[:SOURce]:BB:DM:FILTer:OSAMpling:AUTO
The command activates/deactivates the upsampling factor state. If activated, the most
sensible parameter values are selected. The value depends on the coherence check. If
deactivated, the values can be changed manually.
Parameters:
0 | 1 | OFF | ON
*RST: 1
Software Manual 1008.0858.42 ─ 10
241