R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Graphical User Interface
Baseband Block
Remote command:
​[:​SOURce]:​BB:​DM:​PRAMp:​RDELay​ on page 248
Fall Delay - Power Ramp Control - Digital Modulation
Sets the offset in the falling edge of the envelope at the end of a burst.
A positive value gives rise to a delay, the envelope length increases and a negative value
causes an advance (the envelope length decreases). The setting is expressed in symbols.
Remote command:
​[:​SOURce]:​BB:​DM:​PRAMp:​FDELay​ on page 248
Attenuation - Power Ramp Control - Digital Modulation
Sets the level attenuation relative to the average level for the signal ranges in which the
level is set to "attenuated" (LEV_ATT control signal).
Remote command:
​[:​SOURce]:​BB:​DM:​PRAMp:​ATTenuation​ on page 247
Trigger/Marker/Clock
The "Trigger/Marker/Clock" dialogis accessed via the "Custom Digital Modulation" main
menu.
Software Manual 1008.0858.42 ─ 10
82