R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Remote Control Commands
SOURce:BB:DM Subsystem
Parameters:
Example:
Manual operation:
float
Range: 0 to 50
Increment: 0.1
*RST: 15
Default unit: dB
BB:DM:PRAM:ATT 15 dB
sets a level attenuation of 15 dB.
See "Attenuation - Power Ramp Control - Digital Modulation"
on page 82
[:SOURce]:BB:DM:PRAMp:FDELay
The command sets the delay in the falling edge. A positive value gives rise to a delay
and a negative value causes an advance. The setting is expressed in symbols.
Parameters:
float
Range: -4 to 4
Increment: 0.01
*RST: 0
Default unit: symbol
Example: BB:DM:PRAM:FDEL 1
The falling edge starts 1 symbol later.
Manual operation:
See "Fall Delay - Power Ramp Control - Digital Modulation"
on page 82
[:SOURce]:BB:DM:PRAMp:RDELay
The command sets the delay in the rising edge. A positive value gives rise to a delay and
a negative value causes an advance. The setting is expressed in symbols.
Parameters:
float
Range: -4 to 4
Increment: 0.01
*RST: 0
Default unit: symbol
Example: BB:DM:PRAM:RDEL 1
The rising edge starts 1 symbol later.
Manual operation:
See "Rise Delay - Power Ramp Control - Digital Modulation"
on page 81
[:SOURce]:BB:DM:PRAMp:SHAPe
The command sets the edge shape of the ramp envelope.
Software Manual 1008.0858.42 ─ 10
248