R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Error Messages
Device-Specific Error Messages
Error
Code
Error Description Remedy
200 Cannot access hardware
The data transmission to a module was
unsuccessful.
The module is not installed, not
properly installed or missing.
201 Hardware revision out
of date
A later version of certain parts of the
instrument is necessary to execute the
function selected.
The driver does not support the
installed version of a module.
202 Cannot access the
EEPROM
204 Driver initialization
failed
A error occurs when writing or reading
a EEPROM.
Initialization of a driver fails when booting
the instrument firmware.
The EEPROM might be defect
and has to be replaced.
The driver is not compatible with
the hardware or software configuration
of the instrument.
241 No current list There is no list selected. To execute
the required operation, a list has to be
selected in the related menu. If no list
is available, a new list must be created.
242 Unknown list type
specified
The list type selected is not valid for the
required operation.
For instance, the file extension for
waveform list files is *.wv. It is not possible
to enter another file extension
when selecting a list.
Check the selected list type.
261 Waveform Protected The selected waveform file cannot be
transferred to a controller. The waveform
is produced with simulation software
R&S WinIQSIM2 and is protected.
460 Cannot open file The selected file can not be opened. Check the path and file name.
461 Cannot write file The file can not be written. Check if the file is read-only.
462 Cannot read file The file can not be read. Check if the file contents are compatible
with the file type.
463 Filename missing The required operation cannot be executed
because the file name is not
specified.
A file name has to be entered
when creating a new list.
464 Invalid filename extension
465 File contains invalid
data
The file extension is not valid for the
required operation.
The selected file contains data that is
not valid for the file type.
The file extension determines the data
that is valid for this file type. If the file
extension is changed the lists are no
longer recognized and the data are
therefore invalid.
Example: the extension of a waveform
file (= *.wv) was changed to *.txt
Check the file extension.
For instance, the file extension for
waveform list files is *.wv. It is not
possible to enter another file
extension when storing a list.
Check the file extension.
Software Manual 1008.0858.42 ─ 10
299